I went to the hardware store to pick up some 1/16th rod (brass was all they had), and some #0 ss washers. Well, here is my problem. #0 washers dont go over 1/16 brass rod. for the life of me, it would not fit. I tried numerous washers and numerous rods in that combo, on the off chance that maybe the first one (or two) I picked up was milled bad. no luck.
The next size up in washer is a #1. This seemed a scosh too loose, and I was concerned that when I peened the rod it might not spread enough to be secure... but I wasnt sure.
Everyone who has done a tutorial or post on pinning has always said 1/16 rod and #0 ss washers. so... what gives guys?
what am I missing here?

Any help is appreciated, as I plan to return to the hardware store tomorrow.