Does every wood require stabilization?

[ferroburak]

Hi,
Does every wood require stabilization for scales making? Thanks.

[MinATX]

If the wood has already been dried, it should not be a big problem. It also depends on the species of wood. Since you are in Turkey, I don't know about the species of wood you may be using. But since razor scales are so small, there should not be much wood movement. To be safe, if the wood has already been dried (in a wood kiln or at least a year in the open air for a piece no more than a couple of centimeters thick) cut a piece of wood two or three times as thick and wide as you need. Let it sit in the open air in your home for a couple of days and then cut it to the final dimensions. That way, if the wood bends while it adjusts to the indoors temperature and humidity, there will be enough material left over to make the scales even if you have to cut away any bent parts. After you make the scales and attach them, it helps to coat them with shellac and / or a lacquer to protect it from warping when it gets wet.

[niftyshaving]

Hi,
Does every wood require stabilization for scales making? Thanks.

Dimensional stabilization or sealing against water infiltration?

Once wood is fully dry it should be dimensionally stable.

Some wood needs a finish that seals it against lather,
water and other stuff. Other woods are dense and
have sufficient oil to just use, perhaps with a light wax or
oil finish.

In general follow the same rules and
finish choices that you would apply to
a wooden table. In addition add super glue
to your finish kit. CA can make a fine
finish on razor scales.

[holeHeartless]

I'm less than a novice to scale crafting however i'd have to say no to your question. Ironwood, i would imagine, would be pretty much ready to go as is.

[cpcohen1945]

For building boats, teak wood is oily enough so it doesn't need any protective finish. All other wood needs to be protected from water.

There's a liquid -- PEG (Polyethylene Glycol ???) -- that is used to "stabilize" wood. Soak the wood in it, and the wood becomes very resistant to cracking.

Charles