My first scales

[time2shave]

This is my first go at making scales. I used 3/16 acrylic. I didn't lay them out on the computer, simply traced the old scales and added some extra around the pin.
Pinning was the most unnerving part of the whole operation, as acrylic cracks pretty easily. But it went well. I wish I had some brass washers to put on the outside of the scales, but I didn't have any.

I thought the new scales were going to be too heavy, but they work surprisingly well. I love the tight pivot I was able to achieve. And the blade is centered perfectly in the scales.

All in all, I am pleased with the result. If I was to do it again, I would try and make them a bit slimmer, maybe lay them out on the computer first. I might still take them back to the belt sander and remove more material.

Anyone know a good source for sheet brass, in the 20-50 mil range?

Thanks.