I received a new Dovo Best Quality recently. After a couple attempts to hone it (Norton 4/8K) and not getting the results I expected, I noticed that it wouldn't lay completely flat on one side. The inside edge on the spine is factory ground unevenly compared with the other side (i.e. one side's grind doesn't extend as close to the heel as the other and slightly elevates the heel from the stone). Since I've been doing some light honing with slightly more pressure on the heel side in order to flatten that spot on the spine, I'm worried I will eventually ruin the bevel. Before that happens, I would like some advice. Should I continue to try to flatten that spot with a stone or should I carefully take a dremel to it? Any words of wisdom. Thanks.