Thread: Fun with Verniers calipers and tape

So after some math lessons from Lee we started dialing up razors, we did about 8 each ranging from brand new to slight hone wear....

We found that all the ones we did tonight fell between 13 and 19 degrees

We had mostly hollow grinds to check and there was no correlation between blade size and angle that I found....

Look forward to hearing of everyone else's measurements...

Also.... what about smiling razors????
the big choppers???? that vary on blade width???
That we just measured, and found to be 14 degrees at one end, and 18 degrees at the other, but we use a rolling stroke and we make this an even bevel ?????

So many thoughts.... so many mysteries to solve... I think I'll go hone some razors instead....