I'll leave it all original, just maybe try and bring the etch out a little bit, but then again I guess that is, "patina", and it's long and gone to the time when I should have a razor with, "patina".....:rofl2:
Printable View
I would start light with it. Scrub it good with a toothbrush. Light simple green or something. Perhaps a touch of scouring powder.
A scrap of Scotchbrite and same to scrub inside of the scales. Then rub with a polish, soft towel off. See what you have.
Sometimes scars are attractive if cleaned!
You can always go heavier if you want. You can only go light once! :D
Bar keepers friend is a really good scouring powder I use on softer metals with good results.
Not as aggressive as comet of javex, but great on brass and aluminum..
CDN tire and Walmart carry it as well.
I keep a little pile of it on the back of the shop sink to touch my damp toothbrush to. Works a treat on most every part of a razor, with exceptions, of course. Downward strokes with a pasted toothbrush really gets a blade going nicely.
Takes off lots of rust, esp around pivots, tangs, and jimps.
If that pitting of the scales had happened with the original pin still in, the blade would be loose in the scales. Without having it in hand I cant judge, but unless that blade was flopping about, I would guess that it has already been repinned, if not rescaled.