Results 21 to 29 of 29
Thread: Is My Razor Sharp Enough?
-
12-26-2015, 03:04 AM #21
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795If you are going to lap with sandpaper, then it needs to be wet/dry sandpaper. Regular sandpaper will release grit that can embed into the hone, causing more trouble.
If you drive for a living, you may not want to make the effort, but you would be welcome to drive to my place in Rochester MN (250 miles down I-90) for a honing lesson. Some time with the hones and microscope should help sort you out fairly quickly.
-
12-26-2015, 03:21 AM #22
- Join Date
- Sep 2015
- Location
- Oconomowoc, WI
- Posts
- 12
Thanked: 0Yes, I was going to get some 400 wet/dry. Someone elsewhere on this forum suggested 3M or a good brand, but Menards only had large sheets of the rougher grits. Their 400 wet/dry was barely bigger than my stones. Hopefully, Ace H/W will have it. Thanks for offering a honing lesson. I do get to the Eastern side of MN quite often, but rarely have time to stop and get a bite to eat. I had to deliver a while back in Austin, and then over in Winona. But I'll keep you in mind.
-
12-26-2015, 05:41 PM #23
- Join Date
- Dec 2014
- Location
- Virginia, USA
- Posts
- 2,224
Thanked: 481If you're referring to the half sheet sand paper that measures about 9x3.5 inches, that's what I use to lap my hones. It's approximately the same dimensions as a lapping hone/DMT. When I do get the full size sheets I end up tearing them in half because they don't fit inside the old baking pan I use as a honing/lapping station.
-
12-26-2015, 11:18 PM #24
- Join Date
- Sep 2015
- Location
- Oconomowoc, WI
- Posts
- 12
Thanked: 0The ones I was referring to didn't seem to be half sheet size - instead smaller. Anyway, I already got full size sheets. I had read a lapping thread on here that said put water on counter, then lay the sand paper down on that, then add water, draw lines on the top of the stone w/a pencil, and start lapping.
-
12-26-2015, 11:21 PM #25
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795You do it on the counter if you are single.
If you are married or living with a significant other, then you do it inside an old baking pan or cookie sheet.
-
12-26-2015, 11:22 PM #26
- Join Date
- Dec 2014
- Location
- Virginia, USA
- Posts
- 2,224
Thanked: 481That's the gist of it. I use the baking pan instead of a bare counter top to contain the mess.
-
12-26-2015, 11:23 PM #27
- Join Date
- Sep 2015
- Location
- Oconomowoc, WI
- Posts
- 12
Thanked: 0Sounds like I should too.
-
12-29-2015, 01:26 AM #28
I lap with w&d paper, full sheets on a 1ft2 granite or marble tile I got from home depot. To contain any mess, I sit a lid from one of the 30~ish gallon storage Tupperware containers we have around the house. I sit the lid on the carpet, put down some of that non-slip cabinet liner pad stuff, then the tile, then the sand paper. Because they are designed to be stackable, the lid has a slight/flattened bowl shape to it.
I hope this was helpful.Decades away from full-beard growing abilities.
-
01-01-2016, 10:24 PM #29
- Join Date
- Oct 2015
- Location
- Vermont
- Posts
- 167
Thanked: 8I know the smiling blade struggle well.....The short answer is "rolling x".... learning that stroke in and of itself is a feat, but not without reward. Have fun!