Thread: Looking for advices on different topics (more info inside)

Originally Posted by celticcrusader

Firstly those edges are not mirror polished plus I can see a lot of striations on your bevel which indicate your edge is not refined enough, lapping your stone with 2K sandpaper will not leave your stone with a coarser finish, question how many passes with your razor are you doing on the Chinese hone plus who said it was a 12K hone? those hones are very slow cutters try a 100 laps using a little baby oil then strop on pasted CrOx 30 laps 50 plain linen 60 or 70 leather.

Usually I do around 100 laps. I bought the stone from ebay, the vendor said it was 12K and meant to be used with straight razors.

Thursday I played with the stones and the razor a bit more.
I did around 80 laps on the 6K stone. I tried something unusual (haven't read about it on the forums) I added a drop of liquid soap to the stone and dissolved it with water. The liquid was slightly slick and the blade glided slightly better. I am aware this means the stone was a bit slower, but I liked the effect. Also, it seems to me that the edge's surface improved.

After this, I tried around 40 laps with slurry (thin slurry) in the 12K and every 10 laps I added a couple drops of water. Once the slurry was so think it was barely visible, I switched to the same formula I used on the 6K (water and a drop of soap) and did around 40 more laps.

Finally, I did try the baby oil formula but only did 10 laps because the blade was actually cutting the oil's surface tension and all the oil was sliding above the blade making the underside touch the stone directly.

I went to soap and water again but did only like 10-15 laps before moving to the padded leather strop, then the belt strop and finally a denim square where I do 5 laps with ZERO pressure (I use it just to remove the greasy film formed by the belt strop. I once used a little bit of L'occitane hand cream on it (again, just a drop) and while soft, it always leaves a thin film on the edge)

Have yet to try it because I shave every 3-4 days but it seems the blade is in nice shape. I tried cutting my belly hairs and they fell without effort (I know is not the same but I didn't want a hole in my beard). I usually do some 20 laps on another section of the belt strop where I apply Turtle Wax Polishing compound and it always helps, but this time I decided to skip that step and see how the blade works.

Something to notice: the edge has a smoother finish compared to the photos sent a few days ago. If you look at it with the same magnifier you can still see striations but they seem to be finer.
Will keep the thread updated with photos and the shave results.