Results 1 to 6 of 6
Like Tree14Likes
  • 3 Post By mglindo
  • 3 Post By tcrideshd
  • 3 Post By MisterClean
  • 4 Post By Gasman
  • 1 Post By Jnatcat

Thread: After honing

  1. #1
    Senior Member
    Join Date
    Nov 2017
    Location
    Chandler, AZ
    Posts
    183
    Thanked: 20

    Default After honing

    Im a newbie about 40 shaves in. I've been shaving lately without many cuts or nicks. I felt one of my razors just wasn't doing the job so I sent it in for honing. Feeling that the razor was "shave ready" I proceeded without my usual strop. My first shave after honing didn't really go so well. Some significant cuts and nicks. Id appreciate any thoughts on this. Also should I strop this razor before I use it again?

  2. #2
    Senior Member
    Join Date
    May 2014
    Location
    Bryan, TX
    Posts
    1,251
    Thanked: 228

    Default

    I would contact the person who honed your razor. If he is of any worth he will have you send it back.

    Mike
    Geezer, Dieseld and alschepis like this.

  3. The Following User Says Thank You to mglindo For This Useful Post:

    Geezer (12-10-2017)

  4. #3
    Senior Member blabbermouth tcrideshd's Avatar
    Join Date
    Oct 2013
    Location
    Oakland Tn
    Posts
    6,588
    Thanked: 1894

    Default

    Ok did your hone guy tell you not to strop? And it depends on who you sent it to, some are better than others. Trust me on this one. Plus it will more likely to nick you if it's really sharp if your technique is off. Make sure your lather is good, and stretch the skin well. Try not to set the blade on the skin at too much of an angle, these are some of the reasons for little nicks, but if stretched and your not coming in with too high a pitch you shouldn't be cutting yourself. Tc
    “ I,m getting the impression that everyone thinks I have TIME to fix their bikes”

  5. #4
    Senior Member MisterClean's Avatar
    Join Date
    Jan 2016
    Location
    Prescott Arizona USA
    Posts
    825
    Thanked: 369

    Default

    A fresh honed razor will take less pressure to do its job. The pressure you use will gradually change as the razor dulls over time. Stopping slows this process down.
    Some people here strop before and after each shave, I only strop after each shave and that seems to be what works for me.
    Last edited by MisterClean; 12-10-2017 at 04:42 PM. Reason: grammer
    Freddie

  6. #5
    Skeptical Member Gasman's Avatar
    Join Date
    Nov 2016
    Location
    Colorado Springs
    Posts
    10,539
    Thanked: 2190

    Default

    As TC said, very sharp 8n the hands of a new guy can and will cut you. Now if the angle on the face is correct and you notice pulling whiskers and not slicing thru then id contact the honer again. And i strop before and after every shave. Now 8f i just got a razor from someone who honed 8t for me then i ask if its been stroped. Not that more stroping will hurt it any but an unpracticed hand can damage durring stropping. Thats wby some folks say not to strop a freashly honed razor. You need to know how it works before you personnaly do anything to the edge.
    It's just Sharpening, right?
    Jerry...

  7. #6
    Senior Member Jnatcat's Avatar
    Join Date
    Jun 2017
    Location
    Katy Texas
    Posts
    1,041
    Thanked: 135

    Default

    If you sent the razor out to be honed and who ever honed it did a proper job the razor should have been not only honed but also stropped before sending back to you, if the razor is tugging/pulling after getting it back it could be the razor's edge, technique and or prep so I would try to do a hardy stropping on linen/cotton then leather and have another go and if it's still the same then it may have to be rehoned if your prep is spot on and that's not the issue.
    Dieseld likes this.
    "A Honer's adage "Hone-Shave-Repeat"

    ~William~

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •