Results 1 to 10 of 27
Hybrid View
-
01-28-2008, 12:32 PM #1
It rarely happens to me. Maybe once every couple of months. However, when I got that 9/8" monster from Joe, it took some adjustment and a few nicks until I got used to the size.
-
01-28-2008, 12:53 PM #2
The cuts I've gotten on my face are really no worse then you would get with any other razor. If you're reasonably careful you should be fine. I think the potential for bad cuts is to the hands. Whether while shaving or maintaining your razor, be particularly aware of where both hands are and where they're going.
Jordan
-
01-28-2008, 01:15 PM #3
-
01-28-2008, 04:55 PM #4
- Join Date
- Jan 2008
- Location
- Brookline, MA
- Posts
- 57
Thanked: 0I've been shaving with a str8 for about a month, and only nicked myself once on the neck when I was trying to figure out the angles in the mirror (knock on wood. Full disclosure--I have a full beard and only shave my cheeks and the vertical part of my neck). I'm still trying to figure out how to approach my adam's apple, as the beard grows at a funny angle there.
I used to shave with a trac-2, and don't ever remember nicking myself with that either.
Start slowly, and carefully, and only approach the blade to your skin when you are ready. ALWAYS move the blade in the "right" direction.
Good luck.
Jim
-
01-28-2008, 05:01 PM #5
While I've found this to be true, there is the very distinct possibility that the cut will be longer than those caused by a DE or cartridge razor. I still have the vestiges of a two-inch cut near my left ear. It was no deeper than what a DE would have given me, but it's a good deal longer.
-
01-28-2008, 05:19 PM #6
- Join Date
- May 2005
- Location
- St. Louis, Missouri, United States
- Posts
- 8,454
- Blog Entries
- 2
Thanked: 4942If you start off slow and shave from the dominant hand side burn to jaw first for a few days and then move to the cheek and then switch hands and do the same on the other side of the face follwed by each side of the neck up and down and then take on the chin a little bit at a time, you will likely have less nicks than the person who takes on the whole face from the first. The method described lets you get used to the feel of the razor and the angles necessary to cut. This establishes a comfort level as you learn more.
Good Luck.
Lynn
-
01-28-2008, 05:21 PM #7
I have had two semi-bad cuts and both of those have been on my thumb!!!
Not paying attention when switching hands will do it in a hurry. On my face, I always had more nicks and cuts with a DE and even more than with a Mach3. With a straight, almost never.
-
01-28-2008, 05:41 PM #8
- Join Date
- Jan 2008
- Posts
- 396
Thanked: 4Newb here....
Every time but very shallow. The stiptic pencil is my friend, followed by a rubbing alcohol chaser. I will point out that I am still learning to hone and am starting from a dull razor so each time is either a little better or a little worse as I figure out what I'm doing wrong.
Today's lesson was an edge that is sharp enough for a great WTG shave may not be sharp enough for a great XTG shave and I am experiencing my first case of whisker burn. You can't see it happily, no rash, but I can feel the burn.
- Bob
-
01-28-2008, 06:12 PM #9
- Join Date
- Aug 2006
- Posts
- 3,063
Thanked: 9Here's my opinion: you can still cut yourself even if you have lots of practice and a well-honed straight, and it really doesn't matter if it happens because you are not paying attention or there was an earthquake or whatever. What counts is that you can cut yourself - more so than with an electric, for example.
Have I cut myself - heck yeah, but while I don't enjoy it particularly, it won't stop me in the least. I may have put a couple of small permanent scars on my face but that's OK with me (last time wasn't too long ago - wife and kids around me egging me to hurry up to go out together + a vicious spike wasn't a good combination )
Nevertheless, I haven't used anything else on my face since my very first straight shave, and I don't want to.
Cheers
Ivo
-
01-28-2008, 06:14 PM #10