Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Rust???

  1. #11
    Senior Member gglockner's Avatar
    Join Date
    Jan 2006
    Location
    Grandview Washington
    Posts
    332
    Thanked: 0

    Default

    I was told to only put oil on razors that are not in use.

    Glen

  2. #12
    Senior Member
    Join Date
    Dec 2005
    Location
    Missouri
    Posts
    121
    Thanked: 0

    Default

    I keep a chamois on my dresser. After shaving and rinsing the razor, I wipe dry with my bath towel or hand towel. I then take the razor to my dresser and wipe with the chamios. I lay the opened razor on the chamios while i get dressed, then wipe the razor with the chamios one more time, close the razor and put it away in one of my mugs. I have never had a spec of rust.

    Everybody has thier own method, this is my method.

  3. #13
    Knife & Razor Maker Joe Chandler's Avatar
    Join Date
    Feb 2006
    Location
    Louisiana
    Posts
    1,849
    Thanked: 50

    Default

    Even if your razor stains, it should come off pretty easily with some mild polish. I usually just run my razors under hot tap water for about 15 seconds after shaving, which heats the blade, then wipe dry with a towel. The residual heat dries them very well, after which I'll put them out of the bathroom to air dry for a little while. Absolutely no rust or stains, even without oil or anything. I'll also strop them about 10 rounds after that, too, just to make sure the edge is clean and dry.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •