Results 1 to 7 of 7
Like Tree1Likes
  • 1 Post By AFDavis11

Thread: Stropping

  1. #1
    Trainee
    Join Date
    Jul 2011
    Location
    Lancaster pA
    Posts
    7
    Thanked: 0

    Default Stropping

    As a newbie is there any problem with laying the strop flat on a counter and stropping there I have a 3 inch latigo

    seems like I could accomplish a better smother form while it is stable !!!

  2. #2
    Member AFDavis11's Avatar
    Join Date
    May 2005
    Location
    Virginia
    Posts
    5,726
    Thanked: 1486

    Default

    Probably okay. Just make sure it stays flat. With nothing holding the strop ends in place it can move around. Watch also for the lack of separation between strop and table. It can make stropping more difficult. In the end it still helps to have the strop at elbow height. That way you can swing without effort.
    dave5225 likes this.

  3. #3
    The Hurdy Gurdy Man thebigspendur's Avatar
    Join Date
    May 2005
    Location
    New Mexico
    Posts
    33,044
    Thanked: 5020
    Blog Entries
    4

    Default

    At one time I tried that ages ago. I didn't like it because there was too much of a tendency to hit the surface the strop was lying on and it was more difficult to get the right stropping motion. With a bench strop you can do it because it's a hard surface to begin with and you are elevated of the table. Also you tend to keep it raised at an angle anyway.

    In the end it's best to just earn the proper way. It's difficult to unlearn bad habits later on.
    No matter how many men you kill you can't kill your successor-Emperor Nero

  4. #4
    Senior Member Durhampiper's Avatar
    Join Date
    Jun 2010
    Location
    Durham, NC
    Posts
    472
    Thanked: 86

    Default

    I actually wound up having to strop with a 3" wide piece of leather laid on a countertop for a couple of months a while back, and when I went back to stropping on a hanging strop, I found that my technique had improved a heck of a lot--and this was after having been shaving and stropping for about 7-8 monhts prior. It helped me really master the flip and also taught me what "lightest possible pressure" really felt like. As AFDavis11 says, you'll want to have the surface at about elbow height. I would lay my strop on the edge of the countertop and hold the left end with my left hand, and strop from left to right. I found that I had to go slower than with a hanging strop, and I think that slowing down is what helped me imporve my technique. When I went back to the hanging strop, I also found that I could strop faster than I had been.
    "If you ever get the pipes in good chune, your troubles have just begun."--Seamus Ennis

  5. #5
    Trainee
    Join Date
    Jul 2011
    Location
    Lancaster pA
    Posts
    7
    Thanked: 0

    Default

    Thank to all

  6. #6
    ace
    ace is offline
    Senior Member blabbermouth ace's Avatar
    Join Date
    Dec 2010
    Location
    Virginia
    Posts
    3,362
    Thanked: 581

    Default

    I've done this, and you can create the same setup to mimic a paddle strop with a hanging strop. Place your hanging strop on some books and weigh down the ends with barbell plates. It's a bit less elegant than a proper paddle strop, but it functions the same way.
    Last edited by ace; 07-20-2011 at 12:45 AM.

  7. #7
    The Electrochemist PhatMan's Avatar
    Join Date
    Apr 2009
    Location
    Hastings, UK
    Posts
    1,714
    Thanked: 527

    Default

    Trainee,

    Please have a peek at these stropping videos; I have found them to be most helpful, especially when I get into my stropping doldrums

    ‪straight razor stropping‬‏ - YouTube


    ‪MrAfdavis's Channel‬‏ - YouTube

    ‪MrAfdavis's Channel‬‏ - YouTube

    Have fun !

    Best regards

    Russ

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •