Thread: i need help with razor restoration and just getting a usable edge on the thing.

Originally Posted by Mcbladescar

Hand sanding a blade - Straight Razor Place Wiki

thank you very much freind

Originally Posted by Maxi

Wow...

Wow....

That's a level of rudeness that I've never actually seen on this SRP.

Unsubscribed.

you know what else would be rude , entering a home depot and asking a question and being told to read a carpentry book

Originally Posted by guiltyspark

you know what else would be rude , entering a home depot and asking a question and being told to read a carpentry book

This sounds like every time I go to Home Depot.

Originally Posted by hoglahoo

Are you expecting other customers to hold your hand and walk down the aisles with you?

didnt think an analogy that mindblowingly simple could fly over sombodies head.

i was wrong.

Originally Posted by guiltyspark

didnt think an analogy that mindblowingly simple could fly over sombodies head.

i was wrong.

you're a dick. in the time spent bitching about other people being lazy you could have found the article and read everything you wanted to know.

You have an interesting way of engendering good feelings and helpful attitudes in others.

I am afraid it is you who have misunderstood your own analogy. We are not employees. We are not paid to help you. We are like-minded people who enjoy straight razors. We do not have to put up with rude people if we do not want to.


James.

Originally Posted by ats200

you're a dick. in the time spent bitching about other people being lazy you could have found the article and read everything you wanted to know.

I have all the time in the world to be rude to other rude people on the internet.

What i dont have patience for is people who set up forums with a beginners section and expect people to rift through an entire encyclopedia to find the small information they seek that could be answered quickly in less than a paragraph , or just simply linking the article in question.

Hey Guiltyspark:
sorry to hear of your dremel woes ...been there ... ruined a couple .... if you hang around here a while you will find your work improving due in large part to a few who have responded to your original post ... sometimes these posts can sound off ... but dont let it discourage you , you just need to hang in there and figure them all out ... you WILL get there. I dont think there is a single person in this forum who would not try to help you.
Post some pics of your progress!

Mike

Originally Posted by guiltyspark

hey thanks for the link , next time while visiting a beginner section of a forum to help people out use common sense and provide one instead of wasting your time and everybody elses .

Thread over. There are plenty of beginners that need help, no need to waste time with the trolls.