I plan on trying out .50 micron Chromium Oxide paste. To preven wasting a good piece of leather I would like some advice or opinions on it's proper or preferred application.
1. Does it work better on leather or balsa strops?
2. How long should it be allowed to dry before using?
3. I intend on making the leather strop; therefore I need to know if I should apply neetsfeet oil and allow it to dry before applying the paste?
Onto the honing question. I recently purchased a 12,000 grit stone from a reputable vendor. The stone is from China and is a quarry cut stone. The directions state that all I am required to do is soak for 30 minutes prior to use. While watching the "World of Straight Razor Shaving" DVD, which I am sure everyone here is familiar with, I saw Lynn using a prep stone to develop a "slurry" on his finishing stone. Does anyone know if the 12,000 grit stone requires a slurry for proper cutting?
Lastly, I am now a little confused about how to properly clean my razor while shaving. The documentation that came from the vendor stated to dry wipe the razor on a quality paper towel or soft cloth towel because running water can cause micro chips on the edge. I will refer back to the WSRS DVD again where Lynn is demonstrating his preferred method of shaving; he cleans his razor under the faucet. WHAT IS THE BEST WAY TO PREVENT DAMAGING THE RAZOR? Lynn says to use running water while the factory strongly advises against it. I am just a little confused on this one.
All constructive thoughts and/or ideas are welcome. Thank you all.
Semper Fi and HOOAH