Results 1 to 10 of 16
Thread: Advice re keeping the edge
-
06-02-2013, 04:31 PM #1
- Join Date
- Dec 2011
- Posts
- 5
Thanked: 0Advice re keeping the edge
Hi, All,
I'm not really a beginner--been shaving with a SR for a couple of years now, but, frankly, I very seldom get what I think of as a good shave; by that I mean that I can't seem to get a closeness that even matches the cheap throw-away razors I get at the drug store. I must be doing something wrong. Here are the particulars.
I have two Dovos, which I rotate every other day. I use the Williams Mug soap, which I like as well as anything else I've ever tried. I strop the razor 20 times on the linen and 50 on the leather before each shave. I use a pre-shave oil, and I shave just after getting out of the shower.
My beard is heavy and coarse; Luckily, it's light colored, but I still have to shave every day. It takes me four passes to get a decent shave, and most days I still have to finish the hard areas (jaw line, etc) with the safety razor.
I do get marginally better shaves with the razor after it has been professionally sharpened, for a day or two. This leads me to think that there may be something wrong with my stropping technique that actually takes the edge off. I use a moderate pressure, and I strop briskly.
I do enjoy the Zen of shaving with a SR. It gives me a few minutes of focused repose in the morning before work. However, it has not yet been in my experience comparable to the shave I get from the cheapest disposable. This is after two years of working at it.
What am I doing wrong?
Cheers
Steve
-
06-02-2013, 05:02 PM #2
- Join Date
- Mar 2012
- Location
- Thunder Bay, Ontario, Canada
- Posts
- 17,312
Thanked: 3228I dunno but it might be telling that you only get a day or two of marginally better shaves out of a freshly pro honed razor. That could point towards you stropping incorrectly. I would say slow down and use no pressure and see how that goes. Also too, in addition it might indicate that your shaving technique is not quite there too. It might be that you have to adjust the angle you are using on the blade. I would try keeping about 2 spine widths gap between the blade's spine and your face. If Williams is performing as well as anything else you have tried then possibly your lather may need improving. In all honesty Williams is the poorest performing of the soaps I use but it is usable, definitely not my first choice though. You need to work up a fairly thick moist lather. I could be a combination of those things giving you a sub par shave. May be just make one change at a time and see how it goes.
BobLife is a terminal illness in the end
-
06-02-2013, 05:22 PM #3
I would deffinently make one change at a time. BobH hit that one on the head. +1 you may want to get a finishing hone to refresh your blades until you get the stropping figured out. You really should not be getting bad shaves 2 days after a honing. It also may be you are just that coarse and thick. The YMMV applies here. If you have some tugging or the razor is not performing like it should. You could make a couple passes on say a barbers hone and it should bring that edge back if you are stropping properly. But to reiterate- stropping properly is a must.
-
06-02-2013, 05:29 PM #4
- Join Date
- Nov 2012
- Location
- Across the street from Mickey Mouse in Calif.
- Posts
- 5,320
Thanked: 1184Not mentioned is stretching the skin while shaving. It sounds more like a strop thing though.
Good judgment comes from experience, and experience....well that comes from poor judgment.
-
06-02-2013, 06:56 PM #5
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 27,038
- Blog Entries
- 1
Thanked: 13249Spend more time prepping the beard...
There are two steps to proper stropping,,
1. Do No Harm
2. Improve the edge
You have to without a doubt accomplish step 1 as fast as possible, accomplishing step 2 takes a bit more doing...
-
06-02-2013, 07:02 PM #6
- Join Date
- Dec 2011
- Posts
- 5
Thanked: 0Thanks. Bob. I've tried some other more expensive soaps, but I can't see that they perform any better. I'm guessing it's a strop thing. I read somewhere that if you put too much pressure the edge can actually turn back on itself. I'm going to try a lighter stropping technique and see how that goes. Your advice is much appreciated.
SteveLast edited by SteveAcree; 06-02-2013 at 07:09 PM.
-
06-02-2013, 07:05 PM #7
- Join Date
- Dec 2011
- Posts
- 5
Thanked: 0Thanks, Stone! I'm going to try lightening up on the strop first and see how that goes. I've got a Primble hone that belonged to my grandfather, so I'll make a pass or two over that as well.
Steve
-
06-02-2013, 07:07 PM #8
- Join Date
- Dec 2011
- Posts
- 5
Thanked: 0Thanks, 10P. I do stretch the skin, but it doesn't seem to make much difference. I'm still guessing that my strop technique needs improvement. Gonna start there.
SA
-
06-02-2013, 07:09 PM #9
- Join Date
- Dec 2011
- Posts
- 5
Thanked: 0Thanks, Glen. I put the shave oil on while my face is still wet from the shower, and I work the lather up as thick and moist as I can. I tried a five-minute hot towel, but it didn't seem to make any difference. As you all advise, I'll start changing my strop technique, and we'll see where that goes.
-
06-02-2013, 07:20 PM #10
- Join Date
- May 2005
- Location
- St. Louis, Missouri, United States
- Posts
- 8,454
- Blog Entries
- 2
Thanked: 4942Where do you live?
Maybe you can hook up with one of the guys and with someone watching what you are doing, maybe they can spot what might be the problem and help you improve.
Have fun.