View Poll Results: How is Jockeys doing thus far?
- Voters
- 52. You may not vote on this poll
-
Cool brush, I might be interested in one
41 78.85% -
Eh, not that great.
6 11.54% -
I can't believe you did things like that with power tools and lived to tell the tale.
5 9.62%
Results 1 to 10 of 41
LinkBack URL
About LinkBacksThreaded View
-
03-02-2008, 01:47 AM #15full time shaver, part time poster
- Join Date
- Jan 2008
- Location
- ohio
- Posts
- 305
Thanked: 40
This is the 3rd time I've tried to reply to this and I keep losing my post.
Readers digest version is to look at my attached picture. By spinning down to a 1/2" dowel, you can sand the bottom and sides in the drill press up to 400 grit with no cross grain scratches. Then seal it with your finish (many coats) put it back on the drill press and buff it to a high gloss. Cut the dowel off with a coping saw while spinning slowly and you end up with and automatic center for you forstner bit. The inside of the hole gets sealed up with epoxy or in my case I use Plumbers GOOP.
I'll post some more pictures of some bowls and brushes I just recently done in another thread.
Kilowattkid
Reply With Quote