Page 1 of 2 12 LastLast
Results 1 to 10 of 20
  1. #1
    Senior Member ferroburak's Avatar
    Join Date
    Apr 2010
    Posts
    430
    Thanked: 34

    Default Using oil to soften bristles?

    Hi,
    Is it a good idea to use oil to soften bristles of boar brush? Thanks.

  2. #2
    Senior Member blabbermouth JimmyHAD's Avatar
    Join Date
    Feb 2008
    Posts
    32,564
    Thanked: 11042

    Default

    I strongly doubt it. With use it will get somewhat softer IME. If you don't like the brush get a pure badger or a 'best' badger for soft tips. IMO oil will keep the brush from lathering well, holding water ..... I could be wrong .
    Be careful how you treat people on your way up, you may meet them again on your way back down.

  3. #3
    Master Barber jpm7676's Avatar
    Join Date
    Jun 2009
    Location
    Scranton pa
    Posts
    219
    Thanked: 89

    Default

    Try regular human hair shampoo and conditioner. I use it every few months to clean them

  4. The Following User Says Thank You to jpm7676 For This Useful Post:

    Bazz (09-20-2010)

  5. #4
    Senior Member ferroburak's Avatar
    Join Date
    Apr 2010
    Posts
    430
    Thanked: 34

    Default

    Quote Originally Posted by jpm7676 View Post
    Try regular human hair shampoo and conditioner. I use it every few months to clean them
    I will give it a try.

    Btw I tried a shampoo before but I left it for several hours and results were not good.
    Last edited by ferroburak; 09-16-2010 at 06:10 PM.

  6. #5
    Senior Member blabbermouth niftyshaving's Avatar
    Join Date
    Oct 2009
    Location
    Silicon Valley, CA, USA
    Posts
    3,157
    Thanked: 852

    Default

    Quote Originally Posted by ferroburak View Post
    Hi,
    Is it a good idea to use oil to soften bristles of boar brush? Thanks.
    Just worry your way through half a puck of Williams... that
    will soften it. Take an afternoon or just lather it up a couple
    extra times after shaving for a month or two...

    Do soak the brush in warm water for a min or so prior to using
    it. Soaking softens...

  7. #6
    Senior Member Malacoda's Avatar
    Join Date
    Oct 2009
    Location
    Northern Virginia
    Posts
    380
    Thanked: 193

    Default

    I would advise against anything 'oil' based (i.e. mineral oil, baby oil, hair treatment oil, etc). Two reasons:

    1. Oil and water don't mix. Oily bristles will prevent the brush from hanging onto water - thereby preventing it from properly hydrating the lather

    2. If even a little of that oil should get from the brush to your lather vessel (mug, scuttle, bowl, whatever), that fine coating of oil might also act as a dispersant when you're mixing and make it more difficult to build a proper lather

    Granted, I've only used boar a few times, but as far as I know though, the best, and perhaps only reliable way to soften a boar brush is by breaking it in with regular use. Over time, the hairs will start to split at the ends result in finer tips and a fuller, much softer bloom.
    John

  8. #7
    Lover of the Boar Big_E's Avatar
    Join Date
    Feb 2007
    Location
    Dallas,TX
    Posts
    316
    Thanked: 10

    Default

    Oil can cause bacteria to build up in your brush by trapping loose flakes of skin off your face and germs from around your mouth as you shave. Leave the boar bristles clean.
    I love using boar bristle brushes and let the brush soak in my mug in hot water as I brush my teeth. This is enough time to warm the shaving mug and get the boar bristles just the way I want them. They'll never be as soft as badger but thats the beauty of boar isn't it?
    Ernest

  9. #8
    Senior Member BuddyRockefella's Avatar
    Join Date
    Aug 2010
    Location
    Melbourne, Australia
    Posts
    263
    Thanked: 49

    Default

    try boiling some water and placing the brush in there for 5 mins then apply some hair conditioner and rinse out after a min or two.

  10. The Following User Says Thank You to BuddyRockefella For This Useful Post:

    jpm7676 (09-30-2010)

  11. #9
    They call me Mr Bear. Stubear's Avatar
    Join Date
    Jul 2009
    Location
    Alton, UK
    Posts
    5,715
    Thanked: 1683
    Blog Entries
    3

    Default

    Boiling water might damage the knot though, so be careful of that. I would also avoid oil as it could cause your brush to gum up with crud and the oil could kill your lather.

    It will soften with use, a wash, shampoo and conditioner will also help, as will soaking it in warm water before use.

    If you still find it too scratchy then you might also consider investing in a badger brush as the hairs are softer and finer.

  12. #10
    Senior Member
    Join Date
    Apr 2010
    Location
    Wales
    Posts
    133
    Thanked: 9

    Default

    I read somewhere, that if you use a pre shave oil, you should give your brush a good clean every now and again, as the oil stops the water sticking to the bristles, so i wouls guess no is the answer, as other posts on here have said, warm water and soap will do the trick.

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •