Results 1 to 3 of 3
  1. 03-18-2013, 11:40 AM #1
    Airportcopper
    Airportcopper is offline
    Senior Member Airportcopper's Avatar
    Join Date
    Jun 2012
    Location
    Long Island/Queens N.Y.
    Posts
    1,035
    Thanked: 74

    Default brush restore question

    How do.u determine the knot size?? Is there a tutorial out there on general idea of how to.do a brush restore.ive read some posts on how to.do it..but is there like a pic tutorial
    Reply With Quote Reply With Quote
  2. 03-18-2013, 12:02 PM #2
    gooser
    gooser is offline
    Greaves is my friend !!! gooser's Avatar
    Join Date
    Nov 2012
    Location
    N.East OH
    Posts
    2,297
    Thanked: 307

    Default

    i use this chart and a speed bore bit to kinda measure .. if i had a set of inside calipers id put them in the hole to determine the size and convert to mm ...

    FRACTION TO DECIMAL AND MM TABLE
    Reply With Quote Reply With Quote
  3. 03-18-2013, 12:25 PM #3
    kalerolf
    kalerolf is offline
    Senior Member blabbermouth kalerolf's Avatar
    Join Date
    Jan 2010
    Location
    Amsterdam Holland
    Posts
    2,124
    Thanked: 246

    Default

    Look at the search button. I unknot my brush by squeezing whit a pliers on the bottem of the hair Then you can pick him easy out the handle, most of the time whitout drilling
    Good luck
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules