Results 1 to 10 of 19
Thread: Final Grind question for makers
Threaded View
-
08-05-2014, 04:58 AM #9
I do a bevel just short of joining with a slow moving flat belt and a taped spine. Then reduce the bevel width with a 4" contact wheel. This is on an 8/8 razor so the 4" wheel is only taking material from about 1/3 of the blade width. Spazola saw my razors at the Denver meet.
Edit; I suppose I should add that the blade center line is at 0 degrees to tangent and the bevel is at the tangent point on the 4" wheelLast edited by bluesman7; 08-05-2014 at 04:26 PM.