Results 1 to 10 of 12
Thread: Forging a wootz ingot
Threaded View
-
06-11-2018, 07:22 AM #9
I looked again and it does seem to bounce rather a lot. Well, not a whole lot but too much. I have spring washers between the machine and the nuts, and I think those are the culprit. It doesn't seem to come progressively loose, so I think it is resonating within the margin of the washers. I'm going to try and a) tighten them to remove the springiness, or b) remove them completely and see if the nuts will stay in place with those nylon bushings alone.
This is one of the reasons that I benefit from those videos. It allows me to look in detail at what's going on without tunnel vision.Til shade is gone, til water is gone, Into the shadow with teeth bared, screaming defiance with the last breath.
To spit in Sightblinder’s eye on the Last Day