Results 1 to 10 of 25
Threaded View
-
06-13-2008, 12:06 AM #23
The blade was pretty close to .010 for most of its length it was around .012 near the toe.
I measured using my dial calipers today since they have a smaller footprint for measuring. I found a thin area running perpendicular to the edge .005 about 1” from the heel since I have a 1” wide contact wheel I am going to assume that I was rocking the blade and digging in the side of the wheel.. This does not look like cause of the problem though. Maybe I ground too thin, maybe some type of stress, maybe the razor gnomes are out to get me.
I am giving up on this one. It was a good learning experience.
I started on a frame back today after work.
Charlie