Thread: Damascus Custom Set - need help please.

Originally Posted by Ben325e

Edge durability is directly affected by edge geometry. The wider the angle, the more steel you have supporting the edge. This helps the razor maintain that good geometry for longer. Also if you were to ding a 13 degree razor and a 22 degree razor on your faucet with the exact same amount of pressure, the resulting ding would be worse with the 13 degree razor.

Not really, 'cause if you dinged one of your matched set of totally custom damascus blades on the faucet you'd kill yourself and it wouldn't matter.

I would probably go with a 17 degree angle or so. This might make the spine thicker , but in my book that's a good thing. A thicker spine means more weight, and generally I like shaving with a heavier razor. that's why wedges are popular with many people.

Not sure if it's revelant since these are all 5/8 blades. but just an observation of what I have to look at (lengths eyeballed with a straight edge).

Dovo Micarta - 5 mm, 16 mm -> 18*
Dovo Bergischer Lowe - 5 mm, 16 mm -> 18*
Kinfolks Top-Notch - 5 mm, 17 mm -> 16.9*
Kahnweiler True Edge - 5 mm, 16 mm -> 18*

[quote=Quick;308684]Not really, 'cause if you dinged one of your matched set of totally custom damascus blades on the faucet you'd kill yourself and it wouldn't matter.


LOL, touche!! I concede this point!

Ben325 has once again cut through the Gordian knot of blither-blather and told it like it is!


I generally use my CAD software to determine bladewidth to spine to bevel angle dimensions, but there's more than one way to skin a cat, as they say...


Important reason #2 to have a big, beefy spine--


So you can see even MORE of that cool damascus patterning along the back too!!!!!



In that vein, have you considered a 16/8 blade with a 1/2" spine?

OK, I'll unveil the Power of CAD!

Here's a comparrison of a 17 degree bevel on the left, with a 13 degree bevel on the right.

I measured the blade thickness at a distance of 50 microns from the edge. The 13 degree bevel edge is only 11 microns thickness, the 17 degree bevel is 15 microns thickness, about a 36% increase in thickness.

Very good thread.

Regarding spine width. The usual rule of thumb was that the blade width is approx 3.5 X the thickness of the spine. It seems to vary from 3 to 4.

So your 1/4" thick spine is even thinner than that. The consequence is that the bevel will be wider which will require more time to hone.


Just my $.02,