Results 1 to 10 of 13
Thread: new forge
Threaded View
-
01-30-2009, 06:05 PM #8
Thanks for the comments.
It is the same on both ends there are two shelves.
I have a choke made but could not tell that it made any positive changes. Perhaps I need bigger vent holes like has been suggested to me. There are three of the vents plus the portion of the tube that is not blocked by the 1/8 pipe. The jet is a 1/8 pipe with a cap on it drilled to .5MM - .020”. I made several different jets.
I have several burners that I made this one runs the best over the greatest range of pressures and flows.
It seems to run smooth and heat up quickly.
Charlie