Results 1 to 4 of 4
1LikesThread: Lapping a barber's hone??
LinkBack URL
About LinkBacks-
10-03-2013, 06:12 PM #1Senior Member
- Join Date
- Feb 2013
- Location
- Long Island, NY
- Posts
- 141
Thanked: 23
Lapping a barber's hone??
I have recently acquired a couple of old (vintage) barbers' hones. Can I lap these with my DMT 325? If not, what is the correct way to lap them.
Thank you.
"A friend asks only for your time, not your money"
-
10-03-2013, 06:14 PM #2Senior Member
- Join Date
- Jun 2006
- Location
- The Netherlands
- Posts
- 5,474
Thanked: 656
Barber hones are very hard. I use sandpaper on a kitchen worktop.
Plus ça change, plus c'est la même chose. Jean-Baptiste Alphonse Karr.
-
10-03-2013, 06:33 PM #3At this point in time...
- Join Date
- Jun 2007
- Location
- North Idaho Redoubt
- Posts
- 27,026
- Blog Entries
- 1
Thanked: 13245
DMT followed by a Arkansas stone to smooth it back up is my routine BUT I'll warn you against it unless it really needs it, the finish from the Factories on these is hard to replicate, so don't mess it up unless you really have to...
-
The Following User Says Thank You to gssixgun For This Useful Post:
Hirlau (10-04-2013)
-
10-04-2013, 12:12 AM #4Senior Member
- Join Date
- Jun 2011
- Location
- Perth, Australia
- Posts
- 796
Thanked: 120
Out of the three ive lapped, one came up really good! Like new!
The seccond was nice but still not as smooth as how it origonally was.
The Third, "The American Hone" turned from glass smooth to 400 grit and i cant get this thing back to its origonal state.
So, be carefull lapping these things! As gssixgun said, its hard to get the factory finish back on these things!Geezer likes this.
-
The Following User Says Thank You to Brighty83 For This Useful Post:
Geezer (10-04-2013)
Reply With Quote