Thread: Help! Identifying Turkish Natural Stone

It looks nice. Aside from that, nobody can tell only by pictures if the stone is a finisher or not.

No one else here likely has one of those, so we can't easily tell you if it's like a Thuringian. It is already quite significantly different in one way - most Thuris are fairly soft and easy to slurry, and you say that stone is very hard.

It could be a turkish oil stone? Those were fron Turkey right?

BTW pming you. You got my HAD itching.

Originally Posted by DireStraights

It could be a turkish oil stone? Those were fron Turkey right?

BTW pming you. You got my HAD itching.

Not every stone that comes from Turkey is a Turkey oilstone. It can be called Turkey hone, and, if used with oil, then "Turkey" or "Turkish" oilstone, but it's a different stone from the Turkey oilstone™. Also, probably, the actual Turkey oilstone did not originate from Turkey.

Kritikos Ine

Originally Posted by Vasilis

Not every stone that comes from Turkey is a Turkey oilstone. It can be called Turkey hone, and, if used with oil, then "Turkey" or "Turkish" oilstone, but it's a different stone from the Turkey oilstone™. Also, probably, the actual Turkey oilstone did not originate from Turkey.

If you have ever seen a turkish oilstone they are a dark color. Similar to the stone OP posted. I haven't seen one with red figuring though.

I wasn't trying to be redundant. I don't know how fine they are but I know they're hard. And I don't think they would be called Turkey or Turkish unless they had something in common back in the day.

Originally Posted by Vasilis

Not every stone that comes from Turkey is a Turkey oilstone. It can be called Turkey hone, and, if used with oil, then "Turkey" or "Turkish" oilstone, but it's a different stone from the Turkey oilstone™. Also, probably, the actual Turkey oilstone did not originate from Turkey.

Thanks gents. I lapped the stone with 80/320/1000 w/d sandpaper. I tried to touch up on of my shave-ready razors which was finished on C12k. Unfortunatelly it degraded the edge significantly. I did 50 laps on clean water and check the edge. I didn't like what I saw under magnification. Scratches look like 6-8k pattern in my guesstimation. It didn't shave arm hair above the skin easliy. Did another 50 laps and checked. Little bit improvement. Did another 10 laps and it shaved arm hair above the skin. I stropped on canvas/leather 60/120 laps and this morning I tested the edge on my cheek. Too much pulling, tagging etc. It is not shave ready not even close. It is possible that I made some mistakes in somewhere but in my coticule or bbw I get this result in early stages. May be I should lap it up to 2000 grit sandpaper.