Thread: Naniwa 400

+1, especially if you have a Nagura stone and make a slurry on the 1k. Your perfect tool.

some repairs and work on wedges takes forever on 1k stone, in this case for me 600 Chosera does the job. Sometimes I even go down to 325 DMT.

It depends on how significant the nicks are. Regardless, you should get a 1k before you start going lower. I have used the Naniwa 400SS and the 600 Chosera. Can't go wrong either way.

Thanks all, I was hoping for a shortcut to save a few bucks, plus SRD doesn't currently have the 1k in stock and I'm getting jumpy for hones.

+1

Besides, those low grit hones need a lot of truing-up. some you can literally see dishing-up before your very eyes. If you need to go lower than 1k a diamond plate is the way to go in my opinion. Cheaper and less time-consuming in the long run, plus you can lap your other hones with it.

Regards,
Neil

If your coarsest right now is the 4k then definitely go for the 1k Chosera. That stone actually gives a 2k finish by most other stones' standards, while cutting very fast. That said, for heavy restoration work the Chosera 400 would really speed things up. It gives a finish almost as fine as a King 1000, while cutting far faster.

The Superstone line I have in the higher grits, it's softer and dishes faster, but works great too.

While I agree that a 1k stone needs to enter the mix, I hope the impression is not left that a 400 grit stone is too coarse. A 400 is too coarse to be used just prior to a 4k but a 400 grit stone certainly has a place in the honing arsenal. If damage to the edge is visible to the naked eye, then I see nothing wrong with dramatically speeding up the process with a coarser hone. Once the damage can no longer be seen along the edge, then it is time to move up to the 1k to start setting the bevel. The great thing about the coarser grit hones is that they are much cheaper than the finer ones and they will save you a lot of time.