Thread: 1k NATURAL waterstone?

Hi all,

I've been putting my hones through their paces, trying to become adept at sharpening up e-bay specials, etc. So far, I've tried diamond, nortons (4/8k combo) and a combo coticule. I greatly prefer the coticule to all of the others, even though it cuts a little bit slower (it's a medium hardness coti). Are there any good ~1k natural waterstones for bevel setting/correction that provide a similar experience as a coti or other natural stone? Speed isn't crucial, I just prefer the experience and mystique of using old-timey hones.

Northman

There are some Japanese stones that qualify and some people even use their Coticule with a HEAVY slurry to bevel set also

Start with this thread http://straightrazorpalace.com/hones...400-800-a.html

There are quite a few threads about Natural bevel setters, but if you read most, the prevailing theme is 'Yes it can be done and it is "fun" but not optimal"

The 1k synthetics dominate this area of honing as they are "Cheap" and very very good at it

Even Japanese sword polishers (not exactly known for throwing tradition in the wind) use synthetics for low grit polishing stages. They are better, faster and cheaper. And what is equally important: you can still get them, as many of them as you need.

You can ask Maksim what Jnat he has around that would be good for a bevel setter/1-2K type of stone. I am sure he knows a lot and will let you know...worth the wait if you're into Japanese stones.

There is also the Dalmore Blue, said to be around 2-4K level.

Originally Posted by Scipio

There is also the Dalmore Blue, said to be around 2-4K level.

I had a Dalmore Blue for a while, and I really wouldn't recommend trying to set a bevel with one. Just finding one that is not crazy expensive would be the first big challenge. They are also very hard, so it's difficult to raise a slurry, and they are SLOW cutters. I mean SLOW.

I have heard but not tried the Amakusa Red can be used, but you may have to do a fair bit of lapping to create a surface that has no inclusions. Others have said they couldn't get a good surface. I have also heard but not tried that the Amakusa White can be used.

Originally Posted by Disburden

You can ask Maksim what Jnat he has around that would be good for a bevel setter/1-2K type of stone. I am sure he knows a lot and will let you know...worth the wait if you're into Japanese stones.

To my experience no such stone exist that is good for razors, they are either too slow or can damage the edge.
The closest one to a bevel setter ,I have tried, is Aizu which is fast enough to do the job, but as the most low grit Jnats it tends to release particles that cause micro chipping. Aoto might be a decent substitute but the readily available ones have a lot of toxic inclusions and lines and in general are not that fast to chose over synthetic 1k.

Japanese Amakusa, approximately at 1-2 k level. Some steels it likes and some it does not.