Thread: What am I doing wrong?

Definitely not a razor I'm willing to sacrifice haha. I'm not using X strokes as the hone width is enough the cover the entirety of the blade, thus all of the blade is being honed with normal up/down strokes. Results of the honing look great, as in I'm getting a great looking edge (with the naked eye only), yet it feels very rough with lots of pulling when I go for a shave. I am using tape and tape was used by the original honer.

Pressure? are you using to much, not enough, any? Has the stone been flattened, cleaned? I found with my Norton's I had to take some of the surface off to get to the better grit(smoother stone) not enough water to move the swarf. Most importantly, time. I still find myself sucking at honing. I have sharpened for others(family and friends) but in no way would try to do it as a profession. Take your time and don't try to rush it. If you need a razor to use, buy another to practice with and get this one sharpened buy someone who knows how to. This will give you a benchmark to work to and a razor to shave with.

I think my pressure is fine, maybe. I know I'm getting a lot of streaking/graying on the 8k side so maybe that means I'm pushing down too hard? It doesn't feel like it though. The stone has been lapped/flattened by the person I bought it from who is a respectable member of this forum although there are a few rough patches on the 8k side nearest the corners.

So if there was a milky slurry on the stone you should be using just enough pressure to have the edge slide under the slurry, so if you ease up just a touch on the pressure it should leave some behind. I also agree that if this isn't a razor that is somewhat expendable, perhaps you should rethink the strategy. here are quite a few shave ready razors for not a lot of cash in the classifieds regularly. My logic is that you really should learn to hone on a razor that is free of geometry issues and can take and hold a very nice shaving edge. There are quite a few for $50-75 that are in the classifieds often and periodically even cheaper than that. I think that would be your best avenue. Also if you could sit down with someone that would be the best. A 30X loupe is handy for checking to see if your scratch patterns are even too. It goes really well with the magic marker.

Originally Posted by animalwithin

I'm not using X strokes as the hone width is enough the cover the entirety of the blade, thus all of the blade is being honed with normal up/down strokes. .

Bad idea,,,

Wolfpack, I'd definitely take you up on getting a honing session face to face, since we're both in California! Glen, I thought X-strokes were only for hones or strops that weren't wide enough to cover the entire blade?

Originally Posted by animalwithin

Glen, I thought X-strokes were only for hones or strops that weren't wide enough to cover the entire blade?

Unfortunately there are many posts that say just that...

The simple explanation is that most razors, hones and strops are not near perfectly straight, so that even a slight "Pattern" will help eliminate any problems. The most common problem that arises from straight up & down strokes while honing is a Frown

Note that I said pattern, there are different ones, and most anything that is not straight up and down will work, The "X" Pattern gets recommended the most because it has been demonstrated to work, and is posted on SR related things going back at least 150 years