Thread: Honing a wedge

Just after some quick input guys.

Honing a blunt edge on a wedge - do you tape? Or is the whole point making the whole blade the bevel in effect?

Ta

The way you worded that question really makes me want a pic of this razor a true wedge is very very very rare...

Sorry bout the quality of pics. Did the best with my phone that I could. Don't know if it's a true wedge but I'm sure you can tell me ( I don't think it is though)

Note I've cleaned it up a little. Posted it on theshaving room but my password has gone funky and admin do t seem to want to help so here I'll stay.

Anyway, have taken to it with the wet and dry. Only gone to 600 grit so far. Not sure if I should go any further as the patina is everywhere and I'll probably have to remove tons of metal to get the putting out.

What do you guys think?

Faux ivory scale resin on its way so I can make some scales to match my old school huge barber shop brush from rod neep that will be in the same package. Can't wait.

Ok

No, not a "True Wedge" you can tell from the grind line at the heel or by putting the razor down on a flat surface and looking under there..

Many of these older razors are pretty hone worn by the time we get them, and become more "Wedgy" so you actually have 3 choices


1. Have the Razor re-ground, which of course corrects the geometry but is often not cost effective, nor does it keep the "Heavy" feel to the edge

2. Hone away on the stones, which of course gets to be real fun as you grind away that beautiful Sheffield steel

3. Add tape to correct the geometry back to as close to original as possible, there are actual calculations on how to figure this, me I have a simple system

One Layer of tape on everything
Two layers once the spine wear is over 1mm
Three layers once the spine wear hits 2mm

I don't really like more then three layers as it begins to feel mushy to me, but I just read about somebody using ten layers so I guess you can if you feel lucky

Nice one dude. Will strap one bit of tape on it and give her a couple of strokes.

I know I can't maker all shiny, but I really want to make a good shaver out of her

If you start exactly as you said, and use a Marker to color the edge it will really give you an idea of where the bevel is at with just a few laps

Unless you are an experienced honer and can already read the scratch patterns very well and in that case I apologize


Hone on !!!!