Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 22
Like Tree10Likes

Thread: First Hone Job--Success

  1. #11
    Senior Member feltspanky's Avatar
    Join Date
    Jul 2014
    Location
    Kentucky
    Posts
    707
    Thanked: 92

    Default

    I really like the lighted loupes on the bay. There very inexpensive and I would recommend purchasing two or three with your initial order. The replacement batteries are almost more expensive than the loupes.

  2. The Following User Says Thank You to feltspanky For This Useful Post:

    apipeguy (04-24-2015)

  3. #12
    Senior Member apipeguy's Avatar
    Join Date
    Feb 2015
    Location
    Michigan
    Posts
    776
    Thanked: 173

    Default

    I ordered 2 lighted 40x loupes off of e-bay, $7.50 total and free shipping. Even if they are no good, I'm not really out anything. I'll see what they are like and go from there. Being a tool geek, I really prefer to buy something that is made with a high degree of quality and will last forever.

    Just received two more Naniwa stone holders, so I now have one for each stone. I keep going to the Gerstner web site looking at their oak tool boxes as I am certain I need one for my razor stuff. Already have two for my 1911 tools, etc. That will go over well with the wife, not.

    Probably will also need another bench in my reloading/gunsmithing room for razor work.

    You guys are a bad influence on me.
    Chevhead likes this.

  4. #13
    Senior Member blabbermouth
    Join Date
    Jul 2010
    Location
    Portland, OR
    Posts
    2,697
    Thanked: 830
    Blog Entries
    1

    Default Unusual amount of things done right

    Pipeguy, Bravo!

    If your join date indicates how recently you've taken up the straight, you're way ahead of most.

    'Done right:
    Have a known good test edge to compare your honing to (the Aust).
    Set it down & leave it alone when its not giving the desired results. This is huge.
    You started w/ synthetics - they'll do all blades, rather than the seduction of the naturals to start with.
    You're noticing/paying attention to the incremental improvements (not all bbs, but...).

    To other new shavers - this is not very typical. 'Happens, but not that often. If it takes you longer to get these results - you're like the rest of us.

    Bravo Pipeguy

  5. The Following User Says Thank You to pinklather For This Useful Post:

    apipeguy (04-24-2015)

  6. #14
    Senior Member blabbermouth Haroldg48's Avatar
    Join Date
    Jun 2013
    Location
    Clayton, NC USA
    Posts
    3,341
    Thanked: 866

    Default

    Amen to that. Two years in and I haven't had that honing success yet. Close, but no cigar. I look forward to hitting that same milestone. Congrats!
    Quote Originally Posted by pinklather View Post
    Pipeguy, Bravo!

    If your join date indicates how recently you've taken up the straight, you're way ahead of most.

    'Done right:
    Have a known good test edge to compare your honing to (the Aust).
    Set it down & leave it alone when its not giving the desired results. This is huge.
    You started w/ synthetics - they'll do all blades, rather than the seduction of the naturals to start with.
    You're noticing/paying attention to the incremental improvements (not all bbs, but...).

    To other new shavers - this is not very typical. 'Happens, but not that often. If it takes you longer to get these results - you're like the rest of us.

    Bravo Pipeguy
    Just call me Harold
    ---------------------------
    A bad day at the beach is better than a good day at work!

  7. #15
    Senior Member Crackers's Avatar
    Join Date
    Sep 2013
    Posts
    314
    Thanked: 49

    Default

    Congrats apipeguy, nice work on the first hone to shave. I recon you should maybe not blunt it and shave with it for a while, this would allow you to see if you have a false edge. This happens when the bevel is not set properly but your finisher gets the edge to where it can shave for one or two shaves and then dies. This way you will know if you have worked on your 1K enough, not a criticism just a FYI check that I go through.
    apipeguy likes this.
    A good lather is half the shave.

    William Hone

  8. #16
    Senior Member blabbermouth
    Join Date
    Apr 2012
    Location
    Diamond Bar, CA
    Posts
    6,553
    Thanked: 3215

    Default

    Good glad to see you are making progress. While the tomato will tell you if you have an edge, that is only one aspect of a set bevel.
    When we “set a bevel” we do 3 things, 1. Flatten the bevels, 2. Create the proper angle, (edge and bevel in line with the spine) and 3. Bring the bevels to meet in a sharp, straight, chip free edge.

    The tomato will only tell you about one of those things, if it is sharp enough to cut tomato skin. A simple look through a 3 dollar lighted loupe will tell you all you need to know about the bevel set, in a few seconds and what if anything else, needs to be done.

    Once the bevel is set, the rest is just polishing to get a straighter, more comfortable edge. So while the tomato test will tell you if the edge is sharp, you are flying blind on the rest.

    That you are getting good shaves, says more than the tomato test, make your technique absolutely repeatable. You don’t need to spend a lot to get decent magnification, do get lighted magnification, 3-15 dollars is plenty. It is often cheaper to buy multiple inexpensive lighted loupes than replacing batteries, some hand held magnification eat batteries.

    I like the 60x lighted loupe for 2-3 dollars and the Carson 60-100 lighted scope, 10-15 dollars.

  9. #17
    Senior Member apipeguy's Avatar
    Join Date
    Feb 2015
    Location
    Michigan
    Posts
    776
    Thanked: 173

    Default

    I have shaved with the practice razor a couple times and will again today. So far the edge is holding up well. The two lighted loupes that I ordered should arrive today or tomorrow and I will be excited to try those. My 3x gunsmithing loupe was just not enough.

    Today is my day off and I have a little yard work to do this morning but am hoping to get a little time in on the stones this afternoon.

    Starting to enjoy the honing aspect as much as shaving. My first straight shave was 2-20-15, who would have thought that from something that I dreaded to do, a great new hobby and source of satisfaction would develop.

    I have a bit of gunsmithing work to do that has kind of been just sitting on my bench waiting for me to get to it. I need to retire, again, so I have time for my hobbies.
    Crackers likes this.

  10. #18
    Senior Member blabbermouth
    Join Date
    Apr 2012
    Location
    Diamond Bar, CA
    Posts
    6,553
    Thanked: 3215

    Default

    Here is a good video on checking an edge for bevel set.


  11. The Following User Says Thank You to Euclid440 For This Useful Post:

    apipeguy (04-27-2015)

  12. #19
    Senior Member Crawler's Avatar
    Join Date
    Jan 2015
    Location
    N.E. Indiana
    Posts
    970
    Thanked: 134

    Default

    Quote Originally Posted by feltspanky View Post
    I really like the lighted loupes on the bay. There very inexpensive and I would recommend purchasing two or three with your initial order. The replacement batteries are almost more expensive than the loupes.
    The batteries can actually be had for less money than most people think. $6 for 6 batteries. One simply need know where to look. Like at an "Adult Marital Aides" store... probably has to do with the sheer volume of sales of the specific sizes they carry.

    Note: must be 18, or older.

    I checked the site for one of the local chains, and the price was the same. Shipping, however, was like $5-7 to start for orders under $59. Then the shipping would be free.

    Not affiliated, or sponsoring anything. If you would like further info, pm me. Due to content, I won't even mention the store name in open forum.

    I'm also willing to delete this post if it is considered inappropriate.
    Decades away from full-beard growing abilities.

  13. #20
    illegitimum non carborundum Utopian's Avatar
    Join Date
    Jan 2008
    Location
    Rochester, MN
    Posts
    11,544
    Thanked: 3795
    Blog Entries
    1

    Default

    I shudder to ask, but, what the heck is a cherry tomato test???

Page 2 of 3 FirstFirst 123 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •