Thread: Minimum kit for honing SRs

Originally Posted by Whizbang

ANOTHER UPDATE: I have been getting exceptionally nice edges with the 1k and 3/8K stones. I have sharpened many SRs and have had no problems getting a keen edge and a great shave. Without a doubt the 1k, 3/8k stones are all that is necessary for someone who wants to start honing their own razors.

Having said that, I really wanted to try a finishing stone to see if it made a significant difference...so I recently purchased a Naniwa 12k stone. I must say, it does a very nice job putting that extra special polish on the edge. I hesitate to say it... BUT...the 12k is a welcome addition to my "minimal kit". At this point I don't think I would go to a higher grit...but I have learned in life to "never say never".

This is a Breath of Fresh Air! :

I've written time and time again that if you can't get a CCC (Clean Close Comfortable) shave off of a 8K hone then you are just throwing money down a rat hole by purchasing a higher grit hone.

As was said by the old French knight toward the end of the movie 'Raiders of the Lost Ark'--"You have chosen--'Wisely" as that Naniwa 12K is a real workhorse!

I've sent hundreds of razors back to their owners with a Naniwa 12K edge and never a single complaint.

As Glen has said; Synthetics are a Science; Naturals are a Romance.

For consistency the synthetics are the way to go.

With that said, if you have some funds that you don't mind spending on a White Elephant for a rock that may end up as a paperweight; then you can 'Play' with the naturals.

Again, thank you for taking the time to learn the 8K before going higher and congratulations for having the foresight to purchase that Naniwa 12K as you will never regret that decision.