Results 1 to 6 of 6
Thread: Lapping recommendation for corti
-
04-14-2009, 02:08 PM #1
Lapping recommendation for corti
Hi,
I've never lapped a hone before, let me know what you think might be the better approach--
I just received a 6x2 corti, and I also happen to have a 6x2 600 grit (red-fine) DMT hone in the garage. Would the preferred method be to use sandpaper (per the wiki), or use the DMT? I'm wondering if I might have a hard time making the corti surface flat with the DMT since they are *both* 6x2, whereas I can use a larger piece of sandpaper.
Let me know what you think,
Chief
-
04-14-2009, 02:12 PM #2
Although DMT recommends 325 or coarser for lapping I would use the 600 under running water in the sink. Draw a pencil grid on the stone kind of like a kid's tic-tac-toe game. When the grid is gone your stone is flat. I lap 8" stones with 8" diamond plates regularly.
Be careful how you treat people on your way up, you may meet them again on your way back down.
-
04-14-2009, 05:19 PM #3
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,544
- Blog Entries
- 1
Thanked: 3795What is a corti?
Did you mean coti, for coticule?Last edited by Utopian; 04-14-2009 at 05:48 PM.
-
04-15-2009, 02:24 AM #4
-
04-15-2009, 03:32 AM #5
- Join Date
- Jan 2009
- Posts
- 1,230
Thanked: 278There is a lot to be said for using coarse sandpaper for lapping harder hones, where there is no risk of coarse grit being embedded in the hone. I've used a range of grits starting at 120, and it speeds the task up enormously.
BUT ... a coticule can contain minor imperfections. When I used a DMT D8C to lap mine it revealed two hairline cracks near the edges. But because I took it easy it didn't matter, the stone stayed together and I can't feel the cracks.
If I had been using coarse sandpaper (or even a D8XX) I suspect I would have broken fragments off the surface.
My Coti is a "standard" one, if you have a "select" coti, maybe you wouldn't have to worry about this.
-
04-16-2009, 03:15 AM #6