I put a layer off tape on a dduck to set the bevel on a 1k nani,after some circles and x strokes,i looked at the bevel through my radio shack scope and had a nice even bevel on the left side of the blade,but the right side of the blade had a nice bevel at the toe for about 1" then the bevel got very thin and then the last 3/4" towards the heel it got nice again. The razor has no hone wear to speak of and was close to unused. So i removed the layer of tape and cont. to hone on 1k to get that section of blade a sizeable bevel. After some time and rechecking with the scope it got alittle wider but did not MATCH the whole lenght of the right side of the blade,so i stopped so i would not creat any more spine wear and ran it through the 5k 8k 12k crox ceox then linnen leather and shaved real fine. So my question is why was i having trouble getting an even bevel on just one side of this razor?? Has this ever happened to you guys? DO YOU SMELL WHAT IAM COOKING. thanks