Thread: Microscope picture 10X power of a micro chip on a used rasor.

To get past that chip I would take it to the 1K, working a little pressure, if you don't have a 1K you can rasie some slurry on the 4K to speed it up a bit.

Breadknifing will in most cases mean more work and time than if you just hone it out.

In my own defense, I was taught by gssixgun breadknifing to remove a chip, hence my reply. I have learned something here fellows, thank you!! I have a Shapleigh that exibits these exact symptoms and I have been wondering what to do, the micro chips are right at the toe, and just appear to be a ragged spot where the slight smile ends. I have also been told about over honing, so what happens to the rest of the blade when you keep taking it to a 1 or 4k to try and hone them out? Will you end up with a wire edge? or do you dull it before you start out again?

Thanks all!!

Mike

Originally Posted by mjhammer

In my own defense, I was taught by gssixgun breadknifing to remove a chip, hence my reply. I have learned something here fellows, thank you!! I have a Shapleigh that exibits these exact symptoms and I have been wondering what to do, the micro chips are right at the toe, and just appear to be a ragged spot where the slight smile ends. I have also been told about over honing, so what happens to the rest of the blade when you keep taking it to a 1 or 4k to try and hone them out? Will you end up with a wire edge? or do you dull it before you start out again?

You can avoid radical breadknifing on non major chips by freehanding the blade like a knife & gradually working back down to spine contact. Continued honing on a 1k will overhone the good areas as you repair the bad but a typical 1k edge is not super smooth anyway & any burr etc will be cleaned up as you progress, tho a light pass or 2 on the TNT or a glass will fold the burr over making it even more accessible to the next stone.
If you use magnification you need to educate your eyes to distinguish between microchips & a burr or wire edge. Microchips generally will not disappear on a TNT but a burr or wire usually does. The TNT can then have a dual purpose but I prefer a glass if I suspect a burr.

Breadknifing? That's a new term to me.

Define please.

It is easier to watch the the vid of me teaching the technique to Mike at the Denver meet up google "gssixgun honing denver" and it will pop up


You might want to LISTEN to what I say about not going past the chip when using the many varied degrees of Breadknifing...

There are a couple of vids on there about using it along with warnings about using it wrong.. There is also a vid of me taking out a chip just a touch larger then the one in the pics here, and setting the bevel in 6 minutes...

Ok, nice to see what you look like Glen. Thanks for pointing me to the video.

Interesting spray bottle you have there.

The sound is tough, but I got it with a set of headphones.

Do you use the same kind of technique to remove a frown, or something completely different?