Lifting a worn down hone or a thin hone

[gssixgun]

So I realize that this is not a huge concern to most, but here is a trick I have been using for some time for thin hones, odd shaped hones, and worn out hones..

I like the Hones being up off the table I am honing on, so I most often use either an actual Waterstone holder like the SteelEx or the Shapton System holder ($$$$) or the Hone that have their own bases (Naniwa SS)

A problem occurs when the hones are thin too begin with (Long Swaty, Dragon's Tongue, etc: etc) when you are using the SteelEx type holders, the holder grips on the bottom 1/4 inch of the hone.. Well with thin hones and hones that are weariing down or oddly shaped hones I cheat..

I got a few sheets of 1/4 Plexi from the Glass shop up here they are cut at 8x3 or 8.5x3 to fit most every hone, I also use these for smaller hones like a Escher or a Charnley Forest or even odd shaped hones.. By mounting them on the Plexi with Epoxy I save the labels forever and I make all the bases uniform... The 1/4 thickness of the Plexi lifts the hone so that it is entirely above the holders cutouts.. It gives me quick uniform changes and keeps the hone higher for me.. I just round the edges and mount the Hones/Stones using 2 part Marine Epoxy, make sure you are careful to watch them as they set up, you do not want the hone to slide around on the mount..

Just an old idea I think I have posted before when the question of saving labels came up, but with my Chosera 1k thinning down (25mm to 14mm) I just mounted it, so I thought I would revisit the idea for ease of use also...









As you can see above a Label or the stamps will show through the Epoxy and the Plexi, (the writing is actually on the hone) just make sure you seal the entire edge so you don't allow water to get under there, just make a bead like you would for tub and tile caulking...