Results 1 to 10 of 24
Thread: RODI water to make lather
-
12-04-2010, 11:14 PM #1
- Join Date
- Nov 2010
- Posts
- 22
Thanked: 2RODI water to make lather
I have a RODI filter for my saltwater aquarium and I decided to gather a little of this ultra pure water to see if that would combat the problems I get due to hard water from the tap water we have here in Texas.
I was amazed that with only a little of this RODI water I got an amazingly thick and creamy lather compared to the usual runny and pretty lame lather with water straight from the tap.
So tomorrow when I shave again, Ill fill my scuttle with RODI and microwave it. Then make my lather in a dish and transfer it to the scuttle cup to keep it warm. Ill let everyone know if that makes a difference in the quality of the shave.
By the way, RODI means reverse osmosis and deionized. It is a 5 stage filter that removes every chemical and mineral from the water. The filters are about $100 and produce 100 gallons per day. I have mine hooked up in my bathroom feeding the auto top off system in my fish tank, but you can use one for practically any purpose that requires ultra pure water. Some people wash there cars with it because it does not leave water spots. May be good for a final rinsing of your SR as well to prevent spots.Last edited by Ibreakstuff; 12-04-2010 at 11:16 PM.
-
12-05-2010, 12:26 AM #2
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795Your filter eliminates some, but not all, chemicals from your water.
-
12-05-2010, 12:35 AM #3
- Join Date
- Nov 2010
- Posts
- 22
Thanked: 2What does it miss?
-
12-05-2010, 01:27 AM #4
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795I don't know what filters you have but none of them work perfectly. The filters you have in your home system are not as good as the high grade water filtration systems used in research laboratories that produce 18 megaohm water. The less dissolved ions that are present in water, the higher its electrical resistance. For comparison, distilled water is about 1 megaohm.
I learned the hard way that even those 18 megaohm systems do not remove everything. There was a lot of flooding in my area in 1993, a few months later I noticed that the cell cultures I routinely worked with did not look right. I didn't find out how wrong they were until I analyzed their chromosomes. These cells normally had 40 chromosomes but these now averaged over 90. They had characteristics normally found in tumor cells.
I tried everything I could to figure out what was wrong. I considered everything and went through a few laborious frustrating months before I finally traced it to the culture media that I was making with our "ultrapure" water. Something in the local water was causing chromosomal damage and our highest quality filtration system was not removing it.
I suspected it to be the result of excess field run-off due to the flooding, but I don't know. I contacted the local water plant and they treated me like I was a nut job. I bought the best home filtration system I could find. It clearly could not eliminate all of it but I hoped that it would at least reduce it. My long overdue point is that though I am a huge fan of water filtration, you should be aware that they at best only reduce, not eliminate, contaminates in your water.
-
12-05-2010, 01:41 AM #5
- Join Date
- Nov 2010
- Posts
- 22
Thanked: 2The one I have is Aquarium Water | Reverse Osmosis | RODI Water | ReefKeeper Water | Typhoon 5 stage RODI Reefkeeper 75 GPD
I also have a TDS meter and it always reads 0.
I think though the whole point I was trying to make was for those of us who suffer from hard water the alternative to buying bottled water could be to use a RODI instead.
From what I can tell, the water it produces is far superior to bottled water.
-
The Following User Says Thank You to Ibreakstuff For This Useful Post:
BanjoTom (12-07-2010)
-
12-05-2010, 03:11 AM #6
- Join Date
- Nov 2010
- Posts
- 16
Thanked: 0I'm also into saltwater tanks (25g reef) so I know about RODIs too. From my understanding, most but not exactly everything is removed. Some chemicals may remain, but it is still very pure water. If it works for you continue to use it.
-
12-05-2010, 03:37 AM #7
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795I certainly take your point. I guess the residual scientist in me bristled at the suggestion that "all" chemicals were removed. Then again, I have my doubts about the accuracy of your TDS meter reading zero as well.
Regardless, dissolved solids in your water can interfere with lathering and as you pointed out, bottled water is not ideal. Bottled water has salts in it because they improve the taste but those same salts can interfere with lathering.
-
12-05-2010, 04:45 AM #8
- Join Date
- Nov 2010
- Posts
- 16
Thanked: 0I wouldn't doubt the TDS of 0. All aquarists with properly working RODIs achieve a TDS of 0.
-
12-05-2010, 02:58 PM #9
- Join Date
- Nov 2008
- Posts
- 155
Thanked: 16well now you got me wanting to bring home some water from the lab...
-
12-05-2010, 03:02 PM #10
- Join Date
- Nov 2010
- Posts
- 24
Thanked: 0What is TDS? by Randy Holmes-Farley - Reefkeeping.com
Just a little tidbit of info on total dissolved solids... I am also sure that hobbiest level meters have a bit of tolerance in them... not sure how much the accuracy would/can vary, but from the article, it looks like varience is the rule with TDS meters... all quite acedemic as far as the subject of a lather goes... but hey... Im married to a scientist, so I have arguments like this all the time! LOL
Utopian- Seeing how I am dumb... distilled is "more pure" at 1 Megaohm than "pure" at 18 Megaohm right? That would make sense... I have a black car that gets washed with distilled, to prevent the waterspotting...
Fun post.... I may have to try a distille dlather when I get home