Results 11 to 14 of 14
-
06-10-2015, 01:49 AM #11
Fine steel wool. Smooth it all out, polish with Maas or similar. Back in business.
Acetone is no joke!"Don't be stubborn. You are missing out."
I rest my case.
-
The Following User Says Thank You to sharptonn For This Useful Post:
smolloy (06-10-2015)
-
06-10-2015, 02:08 AM #12
And don't forget to replace some oil on this pivot! Acetone removed it all! Apply a coat of rennaissance wax or car wax on the blade to avoid discolorations.
Last edited by Matheus; 06-10-2015 at 02:10 AM.
-
The Following User Says Thank You to Matheus For This Useful Post:
smolloy (06-10-2015)
-
06-14-2015, 06:59 AM #13
Tom aka sharptonn might be right. Just some 0000 steel wool & polish 'er up. No disassembling!
-
06-14-2015, 12:01 PM #14
- Join Date
- Apr 2012
- Location
- Diamond Bar, CA
- Posts
- 6,553
Thanked: 3215The same for the good brake cleaner… spray brake cleaner on a towel and wipe the blade, when buffing.
Make some sanding sticks, glue some 1 & 2K Wet & Dry to a couple of coffee stir stick & sand between the scales, sand the outside or use the steel wool as suggested. Polish with a good metal polish.
In the future, WD40 and fine steel wool, or some Crocus Cloth from Ace hardware for a satin finish, one sheet lasts a long time.
Leave your razor open, to dry. I use an old thrift store, glass tray from a butter dish and set it open across the dish, so the blade is out of the scales, for good air circulation, after drying on a micro fiber.