Thread: opinion on a wedge

Norm,
i just noticed you are in montreal, you might want to PM vladsch who has been known to do pure art in his restorations and is also located in the Montreal area.

Originally Posted by syslight

Norm,
i just noticed you are in montreal, you might want to PM vladsch who has been known to do pure art in his restorations and is also located in the Montreal area.

Syslight

thanks for the info, I did not know that vladsch was in Montreal, I will get in contact with him sooner or later

regards

Norm

The DD Satin Wedge was one of the last wedge razors manufactured by any company. It was made in response to requests by barbers for a wedge razor. In some ways they are a wedge technically speaking but are much lighter and easier to hone then typical wedges. They are quality razors. The one you have appears to have a wierd frown to it unless thats just the picture. It may take some work to straighten out. I would send it out.

Originally Posted by thebigspendur

The DD Satin Wedge was one of the last wedge razors manufactured by any company. It was made in response to requests by barbers for a wedge razor. In some ways they are a wedge technically speaking but are much lighter and easier to hone then typical wedges. They are quality razors. The one you have appears to have a wierd frown to it unless thats just the picture. It may take some work to straighten out. I would send it out.

Sorry for asking, my English is not perfect but you mean that the edge is not perfectly straight.


Norm.

From my own somewhat limited experience with wedges I don't think they're that much more difficult to hone than hollows. They just might take a bit more time depending on the condition of the edge/bevel. Most of the more recent wedges have at least some small amount of inward curvature from the edge to the spine. Older wedges (Late nineteenth, early twentieth century.) tend to be a bit more slab sided with a "smiling" (curved) edge making it a bit trickier to ensure the entire length of the blade maintains contact with the honing surface. Taping the spine, besides protecting it, slightly increases the angle of the edge on the hone which should improve the results.

I would agree that the edge has a slight "frown" shape. Correcting this is not for a beginner. I would suggest that you contact Joe Chandler or one of the other guys here to hone this razor for you.

BTW, it is a very good quality razor so do not practice on it. As far as wedges being difficult to hone that is usually referring to late 19th or early 20th century english made razors. Wade & Butcher, Wostenholm, Tally Ho etc. They are big and thick. But these are not difficult, except when they have a "frown" shape to the edge.


Just my two cents,

Dubl Ducks can be great razors, but I'm also going to say get rid of the frown. Drawing circles on a fast cutting 1k waterstone would do the job, but you could even go coarser.

X