Results 1 to 4 of 4
  1. #1
    Shavemeister Member Angelous's Avatar
    Join Date
    Aug 2010
    Location
    Dallas, Texas
    Posts
    45
    Thanked: 3

    Exclamation About this Sadler&Co. Straight Razor

    I won this razor in a bid, and was wondering if it was worth cleaning and honing for regular use or if it looks too damaged and should just stay on the self :P

    Vintage Extra Hollow Ground Shaver Straight Razor - eBay (item 370420611092 end time Aug-22-10 13:34:05 PDT)

    Your opinions are more than greatly appreciated guys

  2. #2
    Senior Member jeness's Avatar
    Join Date
    Jun 2010
    Location
    Hungary
    Posts
    797
    Thanked: 219

    Default

    Definitely worth it. I see no big rust marks, or any big blade damage. Sand the blade lightly, polish and hone away.

  3. The Following User Says Thank You to jeness For This Useful Post:

    niftyshaving (08-24-2010)

  4. #3
    Senior Member blabbermouth JimmyHAD's Avatar
    Join Date
    Feb 2008
    Posts
    32,564
    Thanked: 11042

    Default

    Looks to be in good shape. Rather than sanding it I would use some metal polish such as Maas or Semichrome and a paper towel on it. Send it to a honemeister unless you are okay with honing your own.
    Be careful how you treat people on your way up, you may meet them again on your way back down.

  5. The Following User Says Thank You to JimmyHAD For This Useful Post:

    niftyshaving (08-24-2010)

  6. #4
    Senior Member blabbermouth niftyshaving's Avatar
    Join Date
    Oct 2009
    Location
    Silicon Valley, CA, USA
    Posts
    3,157
    Thanked: 852

    Default

    Quote Originally Posted by jeness View Post
    Definitely worth it. I see no big rust marks, or any big blade damage. Sand the blade lightly, polish and hone away.
    +1 on sand lightly. I would start with 3Ms 2000 grit wet/dry
    and remove the small amounts of red rust that I see near the
    toe at the spine (above the E of Extra). Same for the regions
    near the stabilizers at the heal. Use a popsicle stick to help the
    paper get down into the groves.

    Mostly you want to lightly sand for sanitary reasons. The
    rust can harbor old and new bacteria so you want to sand
    them down.

    Lightly oil, wipe clean then hone and strop to shave ready. Then
    shave test...

    If the blade proves to be a good shaver as I expect it will
    you can make decisions on how much more work you want
    to do or have done.

    If it is a good shaver I would then hand polish with MAAS or
    Simichrome Polish. Once a week or once a month when
    one might improve the edge on a CrOx balsa strop or the
    equivalent I would rub the surfaces with polish and a fold of
    paper towel or Q-tip making sure to not wreck the sharp edge...
    After a couple months the blade will sparkle.

    If it later turns out to be an outstanding shaver you might
    have one of the masters give it a once over....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •