Results 131 to 140 of 143
Thread: A Straight Razor Ruler
-
04-10-2017, 08:40 PM #131
- Join Date
- Jan 2017
- Location
- Nebraska
- Posts
- 38
Thanked: 4Thank you , thank you , thank you , for the PDF of the ruler . it will help me a lot .
when i went to print , at first it was huge , found the '' fit to page '' box checked , unchecked it , printed again ,
this time perfect , checked it with regular tape measure . this may help some printers .
once again , Thank you a ton .
Peafowlguy / BrianLast edited by peafowlguy; 04-10-2017 at 08:42 PM.
-
04-10-2017, 08:50 PM #132
I printed to a normal piece of paper in landscape and selected "actual size" in the scaling (which is similar to printing at 100% zoom).
Alternatively, if you can't find these printing adjustments, you can always print, then check against an actual ruler to make sure it is the proper scale.
-
06-03-2017, 07:37 PM #133
- Join Date
- Jun 2017
- Location
- Fort Lauderdale, Florida, USA
- Posts
- 25
Thanked: 5Good afternoon,
I'm new to straight razors and straight razor shaving. Would it be possible to send me a PDF version of your chart, it would be most helpful to measure my purchased straight razors. My email address [email protected].
Thank you in advance,
Pierre
-
06-03-2017, 08:41 PM #134
- Join Date
- Jan 2008
- Location
- Rochester, MN
- Posts
- 11,552
- Blog Entries
- 1
Thanked: 3795If you look through the thread, you should be able to find a link to the PDF. If I remember right, it's in there somewhere.
-
06-04-2017, 04:32 PM #135
- Join Date
- Oct 2015
- Location
- Switzerland
- Posts
- 104
Thanked: 52
-
The Following User Says Thank You to brightred For This Useful Post:
PieErik (06-09-2017)
-
06-04-2017, 07:35 PM #136
RazorGuy...I was just looking for such a thing. Perfect timing!
.pdf? Yes, if you please!
Thanks,
Paul"If you come up to it, and you just can't do it, then that's jolly well where you are."
Lord Buckley
-
06-04-2017, 07:40 PM #137
Hey my friend,
Is this of any help for you? I do hope so;
http://straightrazorpalace.com/razor...ml#post1013972Our house is as Neil left it- an Aladdins cave of 'stuff'.
Kim X
-
06-04-2017, 07:48 PM #138
-
06-04-2017, 08:45 PM #139
- Join Date
- Oct 2015
- Location
- Switzerland
- Posts
- 104
Thanked: 52i prefer the version with the "built-in magnifier": straight-razor-ruler
hans
-
06-09-2017, 12:13 AM #140
I recently printed out some grid paper that has 1/8 inch squares so I can tell how wide my straights are b/c I know some people advertise 6/8 and in fact it is smaller than that. Or it depends some people measure from the spine to edge and some start a little further down. Either way it works great, just have to make sure your printer isn't set to rescale the grid like "fit to size" option will probably shrink it some.