I have gone through the tutorials and tried to answer my question without posting a thread, but I think I may have hit a wall at this point.

I plan on sleeving this razor and I don't know what size tube I should use. The 1/16th fits in what I believe is a 3/32 (the package was an assortment without sizes listed) and they both fit into the razor's pin hole.

Name: sleeve 2.jpg Views: 489 Size: 24.5 KB

When I push it through all the way, you can see that there is still some space on both sides.

Name: sleeve.jpg Views: 442 Size: 23.7 KB

The next size up doesn't quite fit the hole and I would need to do a little bit of filing to get it to fit. I have never done this before so I'm about as green as a banana. I have also looked into thrust washers but I don't know the exact size I would need. Since it is going to be a sleeved pivot, would one of these #0 washers suffice? Micro Fasteners :: Washers :: Flat Washers - Brass :: FWB0 - #0 - Flat Washers - Brass 100 pcs/pkg

Thanks for any and all advice, and I apologize if this is posted in the wrong area.