Search:
Type: Posts; User: pinklather; Keyword(s):
Search: Search took 0.03 seconds.
-
05-20-2011, 10:34 PM
Thread: Spotty Edges
by pinklather- Replies
- 9
- Views
- 857
Yup. You're right, PCB
'Could have a flat point, but the MMT would be clean. But then it wouldn't have an HHT at all.
I went back to the jnat for some more strokes, and the HHT, improved by the crox stropping held up.... -
05-20-2011, 09:14 PM
Thread: Spotty Edges
by pinklather- Replies
- 9
- Views
- 857
Glen, Thank You! This did happen on a few...
Glen, Thank You!
This did happen on a few that were restores, some of which never saw buffers that I know of - I was just honing. One to 4 return trips to bevel dressing slurry on a coti and a... -
05-20-2011, 08:37 PM
Thread: Spotty Edges
by pinklather- Replies
- 9
- Views
- 857
'Certainly possible. (I love your signature...
'Certainly possible.
(I love your signature line!) -
05-20-2011, 07:51 PM
Thread: Spotty Edges
by pinklather- Replies
- 9
- Views
- 857
Crox did help
It did bring quite an improvement, Jimmy. Thank You again.
Can you think of any way I could be introducing it? Unnoticed lifting of the spine? (sometimes happens during circles on one side) Is... -
05-20-2011, 07:43 PM
Thread: Spotty Edges
by pinklather- Replies
- 9
- Views
- 857
Jimmy, Thank You. If I'm introducing the...
Jimmy, Thank You.
If I'm introducing the spots, I'd sure like to know what it is I'm doing and stop it immediately!
Just for reference, I wondered if it was a bevel not fully set, so I tried... -
05-20-2011, 07:28 PM
Thread: Spotty Edges
by pinklather- Replies
- 9
- Views
- 857
Spotty Edges
I've encountered a fair percentage of the last bunch of blades where the edge response to hht is spotty. 'Good in some or most places, but always sections where the performance is poor. I don't know...
Results 1 to 6 of 6