Search:

robellison01.

pyrite was not visible at first, then show up during lapping. I guess if I hone little bit on side of the hone I could determinated how far it goes and then decide either avoid this...

robellison01,

well I read about pyrite on wiki and you might be 100%. it looks like it is pyrite. This also means I can go over pyrite with my edge as it might be damaged.

Well,

after few testing (I am not sure if this is right) I think hone one is something close to Thuringian, just darker. I honed and test one of my razor using hone #1 as finisher and it was very...

Small update,

after performed lapping of stone one I have notices small cranny of (what I think is) copper. You might notice this on some of the pictures. I try hone razor over this cranny and I...

This are side and front pictures:
118348118349118350118351118352

Here is microscope picture (not the best one)
118353

Well,

in fact stone 3 is really pretty but when I will have some more time I will check it honing performance. I will post some microscope pictures fro reference. Also I will try to upload sides...

Piet

in this case yellow stone is not Rozsutec because is not like yours on the picture and is soft like sugar. This stone melts under DMT325. However I have prepared one side on water sandpaper...

Maybe later I will hone one razor with each stone and try to guess grit but for now I am puzzled.

Stone 3
118262118263118264118265118266118267118268

and I need your help. Beside one stone I do not know much about two others. I know that yellow hone is a Rozsutec stone. All hones are presented as:
1.dry
2.wet.
3.slurry.

All stones are soft...