Search:
Type: Posts; User: prodigy; Keyword(s):
Search: Search took 0.01 seconds.
-
02-15-2015, 01:57 AM
Thread: cant do buffalo horn flat :)
by prodigy- Replies
- 8
- Views
- 891
True, I've done it with the scale after its been...
True, I've done it with the scale after its been shaped. Depending on how bad the warp is though it might be necessary to flatten the blank to get a good scale. I use an orbital sander on the 3/8...
-
02-14-2015, 11:41 PM
Thread: cant do buffalo horn flat :)
by prodigy- Replies
- 8
- Views
- 891
I think there are just factors that make them...
I think there are just factors that make them warp, like humidity and temperature. I'm not really an expert so maybe one will chime in soon. I feel that if you pin it properly, while the horn is...
-
02-14-2015, 09:24 PM
Thread: cant do buffalo horn flat :)
by prodigy- Replies
- 8
- Views
- 891
Yes boiling water is the method I used. Do you...
Yes boiling water is the method I used. Do you have pictures of your blanks? Mine were 6 in long x 2 in wide x 3/8 in thick. I boiled them in water until they became soft, usually less than 1-2...
-
02-14-2015, 09:05 PM
Thread: cant do buffalo horn flat :)
by prodigy- Replies
- 8
- Views
- 891
I have two g10 blanks that I ordered too thick...
I have two g10 blanks that I ordered too thick (3/8). I boil the horn until it is soft, place it between the g10 blanks and clamp it down. Not too hard because the horn will split with too much...
Results 1 to 4 of 4