Search:
Type: Posts; User: JDM61; Keyword(s):
Search: Search took 0.01 seconds.
-
03-03-2015, 06:30 AM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
It goes all the way through. That is actually the...
It goes all the way through. That is actually the end pattern repeated down the length of the blade and distorted from drawing it out.. You can see where I forged the points out, but the blades were...
-
03-03-2015, 04:18 AM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
These are two flips that i did a couple of years...
These are two flips that i did a couple of years back. Sorry for the lousy pics. The small blade was lightly twisted W's cut at 45 degrees. The pattern ended up almost looking like waves rising up...
-
03-03-2015, 04:08 AM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
That is slick!!! Simple looking, but when I stare...
That is slick!!! Simple looking, but when I stare at them, they start to look like a 3D drawing of a cube. :D So what are you going to do with them next? Did you do those with hexagon dies?
-
03-03-2015, 12:28 AM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
Thank you, Mr. Blue. It is always a treat to get...
Thank you, Mr. Blue. It is always a treat to get input from someone with as much experience as you have. :D i have done some crushed W billets and twisted one and Ferry flipped a couple, but I have...
-
03-01-2015, 08:32 PM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
Bruno, I know for sure that drilled and "leveled"...
Bruno, I know for sure that drilled and "leveled" raindrop pattern will wash out, but twist and either "cut and leveled" or pressed and ground ladder typically will not. Any pattern pressed into the...
-
03-01-2015, 07:38 AM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
Last time that I heard, he was making some crazy...
Last time that I heard, he was making some crazy high carbon stainless damascus where he uses the moly in ATS34 for the silver color instead of the nickel in the 304 low carbon stainless or pure...
-
03-01-2015, 12:16 AM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
Charlie, i have seen a fair number of his razors,...
Charlie, i have seen a fair number of his razors, kitchen, knives, etc. He is operating on a higher plane because he uses stainless and makes HUGE billets. :dropjaw: I saw a pic of a feather pattern...
-
02-28-2015, 11:52 PM
Thread: Damascus question
by JDM61- Replies
- 20
- Views
- 2,933
Damascus question
I have a question for the makers that use pattern welded steel, either stuff that they make or stuff you get from others smiths. I notice that a lot of the damascus razors use simple patterns like...
Results 1 to 8 of 8