Search:

I have not had an issues with rust. My case sits in a bathroom drawer. I thoroughly dry them after use with toilet paper and coat them lightly with mineral oil. Before I made the box, they just...

Couple of coats of tung oil with some steel wool rub downs in between. Really makes the maple grains pop. The oak top doesn't look as off as I thought - just happen to have some scrap but it turned...

Thank you - you may want to look at foam core - Euclid440 suggested it and I picked up a sheet from a craft store. It really allowed me to play with the design until I figured out the look I...

Thanks to both of you - I value the opinions. I'm going to line the sides with the same felt I have in the bottom so that will keep the razors off the sides. I really needed a 7 razor box and this...

All set with the internals, just to need fix everything permanently and apply the finish. Had to make a box joint jig for the table saw but it was a good experience. Next box will have these nice...

I'll check that out - I think Staples carry's it near me. I have been thinking of a drop in design so that I can also clean the box very easily in case, over time, some oil from the razors stain up...

Oh - I see. thanks

Adam

Thank you both - I really like the design that has the razors help at the top and bottom. As RezDog says - that really is more elegant. In this post - I also like the addition of the rack in the...

Good morning gents,

Almost finished with this straight razor storage box. Maple sides and an oak top and bottom. Top and bottom slip into a dado groove on the sides. I know - strange marriage...