Results 1 to 10 of 43
Hybrid View
-
06-30-2017, 02:38 PM #1
Also, only go with one pass until it clears, with the shavette. I can't do more than one pass or I get bump and whiteheads in the same spot.
Don't strop the new razor, a truly shave ready edge should be good to go right out of the box.
-
06-30-2017, 03:36 PM #2
- Join Date
- Apr 2012
- Location
- Diamond Bar, CA
- Posts
- 6,553
Thanked: 3215It is not unusual for new inexpensive strops to be dehydrated or that could benefit from proper hydration and a bit of oil.
A while back I purchased an inexpensive leather strop from CNTG, it was not a high-quality leather and was very dry. A hydration treatment, over about a month, improved the condition of the leather, it is now a decent strop that could easily maintain a razor.
Your wrinkles may be from the cut of the leather, or from folding, during storage or shipping, but properly hydrated it should be as soft as a well washed sock and many of the wrinkles should come out or at least not be detrimental to a bevel or edge.
Some photos of the strop could help in advising you. I is not uncommon for new guys to have issues stropping and damage the strop while learning, (it can take up to a year to develop good stropping technique). So, a strop of the CNTG quality is perfectly acceptable for learning the skill.
As your stropping improves, so too will your edges and shaves, then is a good time to upgrade to a quality strop, where the strop can make a difference.
Worst case it can be converted to a pasted strop for knives or tools. Post some photos and use light pressure.
-
06-30-2017, 11:21 PM #3
- Join Date
- Jun 2017
- Location
- Victoria, Australia
- Posts
- 57
Thanked: 1Cheers for the advice on the strop. I am going to try and hydrate it and see if it helps.
I did practice on a piece of newspaper first to find the right amount of pressure to use but I guess I might of rushed to the strop a bit to quickly.
I will try and post a photo of my strop when I get a chance. But like I said, I am 99% sure that it is my doing.
As the saying goes "a bad craftsman always blames his tools".
Sent from my iPhone using Tapatalk
-
06-30-2017, 11:16 PM #4
- Join Date
- Jun 2017
- Location
- Victoria, Australia
- Posts
- 57
Thanked: 1