Results 1 to 10 of 14
Thread: Major 'grabbing' when xtg
-
07-07-2009, 12:05 PM #1
- Join Date
- Apr 2009
- Posts
- 8
Thanked: 0Major 'grabbing' when xtg
I've just started trying xtg on the difficult areas - mustache and under bottom lip. I can do my throat fine - get a much better result than with Mach 3 or KoS razors.
But I have problems going xtg on mustache and below my bottom lip. My mustache hair grows at 45degree angle down and away from my nose. It's very coarse, and even new multi-blades don't shave this smooth unless I soak my face first for a long time.
When I try xtg on this, the razor really catches on the stubble, I have to push hard to get it through. Does anyone else have this problem?
I'm thinking of sending it away to be honed professionally, as I guess my problem could be lack of sharpness.
-
07-07-2009, 12:09 PM #2
- Join Date
- Jan 2009
- Location
- Stay away stalker!
- Posts
- 4,578
- Blog Entries
- 1
Thanked: 1262If you feel the need to push, stop!
I had this problem before and it is what really clued me in that my blades were not as sharp as they could be.
I also try to keep the blade as flat as possible. Try doing more of a buffing motion instead also.
but yeah... Upper lip is a senstive area, at least for me.
-
07-07-2009, 12:15 PM #3
- Join Date
- Apr 2009
- Posts
- 8
Thanked: 0thanks, and I've just realized I've been writing nonsense.
I'm talking about shaving Against The Grain, not xtg. Twit.
-
07-07-2009, 12:18 PM #4
- Join Date
- Mar 2008
- Location
- Berlin
- Posts
- 3,490
Thanked: 1903
-
07-07-2009, 12:24 PM #5
I have had similar problems with dull razors, wrong razor angle and improper stretching.
If your razor shaves well in other areas it could be technique rather than dull? Try stretching more and pay a little more attention to blade angle. I have found the best angle is by starting out flat with the razor and slowly raising the angle until the razor starts shaving. That is the proper angle to maintain.
It sounds like you are doing great, hang in there.
Good luck,
Rick
-
07-07-2009, 01:19 PM #6
I go along with Raudrive. IME if the razor isn't cutting smoothly it is either lack of adequate keenness, inadequate preparation, lack of technique (stretching properly) or all of the above.
Be careful how you treat people on your way up, you may meet them again on your way back down.
-
07-07-2009, 02:06 PM #7
- Join Date
- Mar 2009
- Location
- Central Texas
- Posts
- 603
Thanked: 143I find that for tough areas like this I need to do two things (in addition to all the "right stuff" like good prep, good stropping, etc.):
- Use short strokes.
- Use a slicing/guillotine action as described at Shaving passes - Straight Razor Place Wiki
-
07-07-2009, 02:18 PM #8
- Join Date
- Apr 2009
- Posts
- 8
Thanked: 0how do you manage to do the slicing motion when doing under your nose?
-
07-07-2009, 02:24 PM #9
Carefully.
Here is one way to do it.
Be careful how you treat people on your way up, you may meet them again on your way back down.
-
07-07-2009, 04:55 PM #10
- Join Date
- Mar 2009
- Location
- Central Texas
- Posts
- 603
Thanked: 143