Results 1 to 10 of 47
Hybrid View
-
01-04-2012, 10:18 AM #1
- Join Date
- Apr 2011
- Posts
- 57
Thanked: 5You know what I've found... Pulling the skin tightly isn't always best for me. Especially under the chin, I get a much better and much more comfortable shave when I put my head/neck down and make the pass with my razor. I had exactly the same problem until I started doing this.
-
The Following User Says Thank You to THG For This Useful Post:
jawman (01-04-2012)
-
01-04-2012, 11:01 AM #2
Yep, i get that when I use DEs sometimes. Try a str8t. You can control the agressiveness by the holding angle. I also use noxzema (in a tub) as pre shave. It is thick and provides a cushion.. The best thing is you can buy it for cheap anywhere.
Last edited by Wintchase; 01-04-2012 at 11:04 AM.
-
01-04-2012, 12:09 PM #3
I'd concentrate more on the causes of your problem than treatment of it. You want to change your routine so you won't have to treat the razor burn at all. I'd start by eliminating all your pre-shave routine except some warm water splashed on the face and then just shave WTG once to see what happens. That should be diagnostic in itself.
-
01-04-2012, 01:24 PM #4
- Join Date
- Sep 2009
- Location
- SE Oklahoma/NE Texas
- Posts
- 7,285
- Blog Entries
- 4
Thanked: 1936#1, move on up to a straight. I too am razor burn sensitive and have found that the only thing that worked for me was an alcohol based aftershave, especially during the summer months. Even when I started shaving with a straight I would get it if I didn't use alcohol based AS. The alum block is now a part of my arsenal as well.
My routine: After the shave I will rinse my face in cold water, rub the alum block over the my wet face and blot dry. I finish getting ready (teeth, deodorant, etc.) and last thing before I leave the bathroom is apply my AS.Southeastern Oklahoma/Northeastern Texas helper. Please don't hesitate to contact me.
Thank you and God Bless, Scott
-
01-04-2012, 01:50 PM #5
- Join Date
- Aug 2009
- Location
- Waynesboro, PA
- Posts
- 997
- Blog Entries
- 6
Thanked: 199Good recommendations above!
As stated, you might try a straight razor. I had always suffered from razor burn on my neck as well until I started using a straight. It might not have cleared up 100% but it's barely noticeable now.
In addition to the alum block (I've never used one) try lightly massaging your face with witch hazel after you shave. One of it's properties is to reduce irritation, and I find it works great for razor burn, nicks, etc.
-
The Following User Says Thank You to avatar1999 For This Useful Post:
jawman (01-04-2012)
-
01-04-2012, 04:06 PM #6
Closing the barn door after the horse leaves isn't the answer. If you get razor burn trying to treat it is difficult. I know of no product that will really treat moderate burn. The best product I can think of is Thayers superhazel.
Burn means damaged skin so you have to figure out what is causing it. I'd be willing to bet you are using too much pressure on the razor even if you think you are not. I've been using straights for years now and use a DE on a regular basis too and recently bought a Muhle R41 open comb and I'll tell you I thought I was using minimal pressure with a straight but using that razor has showed me that is simply not the case and I've had to reevaluate the pressure issue. You might also want to check the angle you are using.No matter how many men you kill you can't kill your successor-Emperor Nero
-
01-04-2012, 04:41 PM #7
- Join Date
- Feb 2011
- Location
- Austin, Texas
- Posts
- 280
Thanked: 39I got exactly the same problem for many years, and my neck looked exactly like yours.
Switching to a DE and only shaving WTG with light pressure stopped the razor burn. But I assume you have the same issue I have: a tough, full beard that needs something more aggressive than WTG if you don't want a shave that makes you look like haven't shaved yet. I experimented with different XTG directions on my neck. The hairs there grow straight up. If I shave them in a somewhat sideward direction, it shaves much closer. I can't go ATG on my neck with a DE. No matter what razor or blade, it always creates irritation. I think what happens is that the blade, being fixed at an unchangeable angle, grabs the hair and pulls it up a bit before cutting it, probably catching a bit of the skin at the base of the hair.
My big change came when I switched to a straight. I can shave closer with that than ever before, including a XTG / ATG stroke that I do on the neck, leaving it very smooth without irritation. The key factor I think is that you can lay a straight flat against the skin so that it cuts the hair where it leaves the follicle without pulling it upwards and catching a bit of skin.
So these are some key things to do:
use light pressure, just the weight of the razor, don't press it into the skin. Pay attention to the direction of growth and only do WTG for now, adding new factors one by one to see what works and what doesn't. Once you can get some kind of shave, never mind close for now, without irritation, consider trying a straight.
Also, are you using a good shaving soap? That can make a big difference too.
-
01-04-2012, 07:35 PM #8
- Join Date
- Jan 2012
- Location
- Los Angeles, CA
- Posts
- 11
Thanked: 0
-
01-04-2012, 08:01 PM #9
Many great ideas posted. When I have mentored two of my friends and they get this I fall on a couple of things.
1) You might need a different blade. As mentioned previously try a sample pack and see what works best. If the blade is uncomfortable as you shave then don't expect it to get better, it's not wine so it won't get better with age. If you have the sample pack, toss the razor you're using and try another. Also, if you have a sample pack it never hurts to take notes. Use a blade and write down how it felt, smoothness of the shave, irritation... etc. Then compare notes and go from there.
2) Be mindful of the pressure you are using. The weight of the razor should be all you need. If you have sensitive skin then applying added pressure will cause burn no matter the blade you use. Just enough pressure to keep the razor on your face but not too little that the razor skips or tugs hairs.
3) Focus on a good pre-shave routine. Trying different ideas and techniques may be the ticket. There are many different things to try but a hot shower before and good lather goes a long way.
4) Post shave is just as important. Blot dry. Never rub dry. One of my buddies noticed when he applied an aftershave balm the skin would throb... the problem later went away when he reduced the pressure on his DE.
The alum block is used after the shave is complete and helps close the pores. Simply wet it and wipe on. The hazel is a natural astringent and can be applied after the alum block.
-
01-04-2012, 07:26 PM #10
- Join Date
- Jan 2012
- Location
- Los Angeles, CA
- Posts
- 11
Thanked: 0