Results 1 to 10 of 14
-
07-18-2014, 12:54 AM #1
"Taylor of Old Bond Street" for Dummies!
I'm looking for pointers on quickly whipping up a good lather with Taylors hard Sandlewood soap. It so for takes me maybe 5 minutes to get it right. I don't mind the time, but there 'must' be something that I am doing wrong to take so long.
I pre-soak the top of the cake with enough water to form a thin layer on top, for maybe 15 minutes. I then pour a small portion of that pre-soak water into my 5" bowl, load the brush for maybe 30 seconds and then get with the whipping. It seems really tough to load enough soap onto the brush (Silver Tip Badger) in one loading. I load, whip, load whip, sprinkle some water, load whip, etc. Any advice to speed this up would be greatly appreciated..."A man cannot be comfortable without his own approval"... Mark Twain
-
07-18-2014, 01:00 AM #2
Try a boar brush. The stiffer bristle will wick up more soap from a hard puck. You can also try soaking the brush while soaking the soap and that should aid in loading as well.
These are the methods I use with Williams and that is a notoriously difficult soap to lather
-
07-18-2014, 01:06 AM #3
Might need to try the boars hair. I do soak my brush, as well as my bowl in hot water right up till I start whipping lather.
"A man cannot be comfortable without his own approval"... Mark Twain
-
07-18-2014, 01:07 AM #4
I don't think you will get better lather but you may get to the lather you want much quicker. YMMV
-
07-18-2014, 01:21 AM #5
Couple things that may help... or not. Try hot water to soak the puck. Use a little more water to soak the puck. lad the brush for a longer period of time.
Every soap has its own personality. As far as a boar bristle brush, I really like it for face lathering but don't have as much luck using it to whip up a lather in a bowl.
Let us know how it goes!The older I get the more I realize how little I actually know.
-
The Following User Says Thank You to MattCB For This Useful Post:
Hirlau (07-18-2014)
-
07-18-2014, 02:27 AM #6
Like Matt said,,,,,,,,
or,
I soak the brush in warm water, put a small amount of warm water on the puck ( my pucks are in bowls that allow lathering in that same bowl as the puck) , pull the warm brush out of the soak cup , light squeeze, then lather it on top of the puck, great thick lather in a minute.
-
07-18-2014, 05:46 AM #7
Like the others have said only part of your process I see as an issue would be the super soft silvertip badger on a hard soap. I use TOBS in all varieties with no issue when using a stiffer brush. Not always boar though. I tend to stick with the pure/ best badger grades most of the time. Soft but still has backbone for soaps. A good boar brush would work it into a lather faster for sure, but may have to change your water increments depending on the brush.
"The black smoke is just lost power"
-
07-18-2014, 05:52 AM #8
I had an issue with that puck also .. I found I was to liberal (there's a first ..lol) with how much water I was actually using ...
but yes all the others have gave good tips !
-
07-19-2014, 08:27 PM #9
I'm going to try shaving an ultra thin slice of soap from the top of the cake, put it in my bowl along with a drizzle of hot water and see what happens after the soap shaving softens... ?
"A man cannot be comfortable without his own approval"... Mark Twain
-
07-19-2014, 09:27 PM #10
Give it a shot. This part of wet shaving can really vary for a lot of people. This is also one of the reason I like my creams.
The older I get the more I realize how little I actually know.